Bedienungsanleitung Team ST 45 (Seite 9 von 40) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487582

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good



the page numbering. Keep the language integrity.

9 TEAM ST 45 - 100122

Assembly page 9/40

Fax +32 2 359 95 50

ASSEMBLING THE VACUUM CLEANER

 Always remove the plug from the power socket before fitting or removing accessories!

 Insert the hose connector into the hose connection inlet and turn it clockwise until it locks.

To remove the hose, turn the hose connector anticlockwise and pull at the hose

connector.

 Fit the tube to the handle.

 Fit the tube to the floor brush.

 Removing tube and accessories: to remove the accessories, pull firmly apart.

 The floor brush is ideal for the daily cleaning of carpets and hard floors.

Setting with the bristles inside for cleaning carpets.

Setting with the bristles outside for cleaning hard floors.

 The appliance is delivered with the following accessories:

 a crevice tool: for radiators, crevices, corners, baseboards

and between cushions.

 an upholstery brush: for curtains, cushions, edges, doors,

mattresses etc.

OPERATION

 Unroll a sufficient length of power cord and insert the plug into the power socket. Make

sure the carrying handle is in low position. Switch on the appliance by pressing the ON/OFF

switch (carrying handle) with your foot.

 You can adjust the suction power by using the wind-force adjuster on the handle. Use a

low suction power for furniture and other delicate surfaces and use high suction power for

fitted carpet and other floors.

AFTER USE

 Stop the vacuum cleaner by pressing the ON/OFF switch (carrying handle).

 Unplug the appliance from the power supply.

 Roll the power cord around the cord storage facility at the back of the appliance.

 The carrying handle can be used to move the appliance. Never use the handle of the

dust container to carry the appliance!

 After use we advise you to empty the dust collector to avoid smells and mildew that could

be caused by damp dust particles that may have been vacuumed, and also to

guarantee an optimal efficiency during the next use. To do so, see below.

EMPTYING THE DUST COLLECTOR

 Press the release button of the dust container and pull the dust container out.

 Remove the lid of the dust container by turning it anticlockwise and spill the rubbish.

 Turn the lid back on the dust collector and put the dust collector back in the appliance

until it locks in place.

CLEANING THE FILTERS

Filters

The filter system consists of: 1 accordion filter to vacuum the smallest particles (in the dust

container)

1 nylon filter (around the accordion filter)

It is necessary to clean the filters regularly to avoid operating problems.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team ST 45 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info