Bedienungsanleitung Team VCB 6560 (Seite 11 von 32) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487595

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don’t change

the page numbering. Keep the language integrity.

Assembly page 11/32

Fax +32 2 359 95 50

 Simply press lightly with your foot on cable rewind button on top of cleaner. If the cord

does not enter completely in the appliance, pull 50 cm of the power cord out of the

appliance and try again.

FILTERS

To reach the filters situated in the durst collector, press the release button (B) and remove the

dust collector (Fig. 7). For practical reasons, it is recommended to remove the hose from the

connection inlet first.

The filter system consists of:

 a main filter that stops the particles and allows the storage in the dust collector. This

filter plays the same role as a regular dust bag. This filter consists of 2 parts, a hard

bracket and a textile part fixed on an elastomer seam. To replace a dirty filter,

separate the bracket from this textile part by pulling at the elastomer seam and put a

new filter in the bracket by inserting it in the edge of the seam.

 a motor protection filter which catches larger particles in case the main filter wouldn't

have caught them. This filter is an additional protection for the motor but must not be

used as the only filter.

 an air filter situated in the air outlet grid (E) and filtering small particles rejected by the

motor.

Changing and cleaning the filters

A) Main filter

If you notice a loss of suction power, this means that the filter is full and must be replaced. The

replacing frequency depends both on the operation frequency and on the type of dust you

vacuum. For instance very small particles of plaster or concrete will stick to the filter very easily.

To reduce the replacing frequency, you can either remove the bigger particles obstructing the

filter, or shake the filter above the dustbin. Never try to clean the filter with a brush or water.

Filters are available at your retailer's.

B) Motor protection filter

Theoretically this filter must not be replaced, as the main filter catches almost all the

vacuumed dust particles, but if it is dirty, you can clean it. To do so, take it out of the appliance

and wipe it. You can also make use of some soapy water, but make sure it is completely dry

before putting it back in the appliance.

C) Air filter

 This filter guarantees fresh air during cleaning. It should be rinsed clean at least three times

a year or when it becomes visibly solid.

 Unplug the appliance, open the air outlet grille and remove the filter. Replace it and close

the grille.

D) Dust collector

Clean the inside of the dust collector with a damp cloth or sponge, but make sure it is totally

dry before using the appliance again.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team VCB 6560 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info