Bedienungsanleitung Team zb 2 k (Seite 7 von 19) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

402377

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

Generated by Unregistered Batch DOC TO PDF Converter

2011.3.804.1511, please register!

Copies of the I/B. Please reproduce them without any changes

except under special instruction from Team International

BELGIUM. The page must reproduced and folded in order to

obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).

The page must be folded in order to keep the good numbering

when you turn the page of the I/B . Don’t change the page

numbering. Keep the languages integrity.

Assembly page 7/19

Fax +32 2 359 95 50



your teeth (D) and then the insides (E). Be sure to get into the spaces between your teeth as well

as along the gum line (F).

 During the first few days of using, your gums may bleed slightly, particularly if they normally

tend to do so. After a few days, the bleeding will generally stop. If your gums continue to bleed

after 2 weeks, you should see your dentist.

 When you have finished to clean your teeth switch your appliance off by pushing on the key “0”

of the switch (A) before taking the brush out of your mouth.

 After use rinse thoroughly the brush head under running water. You can eventually rinse the

inside of the brushead and the toothbrush, but never let water come in the batteries compartment.

 Dry the plastic parts before tidying your appliance.

HOW TO REMOVE THE BRUSH HEAD

 To maximise the capacity of the toothbrush, the dentists recommend to change the brush head

every three months. Of course this periodicity can change according to the uses. It is

recommended to keep an eye on the situation of the strands. Curved strands mean that the

exchange of the brush head is necessary (G). But if you change the brush heads too often, this

can also mean that you press to hard on your teeth during the cleaning.

 To remove the brush head, hold the body of the tooth brush firmly and pull the head. To place

the new head, push it on the power unit, until you hear clicking. Please pay attention to place the

brush in the same direction as the switch.

 To obtain the substitute brush heads, go and see your dealer.

HOW TO REPLACE THE BATTERIES

 To obtain the best performances of your tooth brush, it is recommended to use LR6 AA-alkaline

batteries (1.5V). To remove the batteries hold the body of the appliance and pull the lid at the

back side of the appliance (H). Place the new batteries in the way indicated on the lid or in the

compartment.

 To replace the lid, push it on the back side of the appliance, until you hear clicking. Pay attention

to place the part, on which the direction of the batteries is described, on the side of the switch.

 Attention: if you don’t use your appliance for a long time, it is recommended to remove the

batteries from the appliance because it could run and create shorts that are bad for the

motor.

1 YEAR WARRANTY

Your toothbrush has a warranty against material and fabrication defects during 1 year.

Guarantee claims will not be accepted if the appliance was improperly used or damaged by own fault.

Guarantee claims will not be accepted for brush heads and batteries because those have to be changed

regularly.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team zb 2 k Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info