Adjusting speaker output level
15
RQT5861
Preparations
Adjust the level of the speakers so they are the same apparent level
as the front speakers when you are sitting where you would
normally enjoy a source.
1 Press [A] or [BI-WIRE] to turn on
SPEAKERS A or BI-WIRE.
You cannot adjust output level when SPEAKERS B is on.
2 Press [TEST] to output the test signal.
DSP sound mode switches to SURROUND mode.
The signal is output from each speaker in order for about two
seconds each:
L: Front speaker (left)
C: Center speaker
R: Front speaker (right)
RS: Surround speaker (right)
LS: Surround speaker (left)
SW: Subwoofer
Speakers set as “NONE” or “NO” are skipped.
The test signal will not be output if the VGCA (
\
page 20) or
DVD 6CH INPUT is on (
\
page 19).
3 Adjust the volume to the level
normally used.
Adjust the balance of the front speakers if necessary
(
\
page 21).
4 Press [LEVEL] to select the speaker
channel to adjust.
The current level appears on the display.
Press again to change the speaker channel.
Speakers set as “NONE” or “NO” are skipped.
5 Press [+] or [–] to adjust the level to
the same apparent level as the front
speakers.
C, RS, and LS can be adjusted between –10 dB and +10 dB,
with zero being the current level of the front speakers.
SW can be set to MIN, between 1 to 19, or MAX.
Repeat steps 4 and 5 for each speaker channel.
6 Press [TEST] to stop the test signal.
For your reference
Subwoofer output is easily influenced by the source played. You
can achieve better results by adjusting its output while listening to a
source (
\
page 21).
Note
1
2
3
4
5
6
