Bedienungsanleitung Technics SA-DA8 (Seite 50 von 52) (Englisch)

536237

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

RQT5518

Troubleshooting guide

Before requesting service for this unit, check the chart below for a

possible cause of the problem you are experiencing. Some simple

checks or a minor adjustment on your part may eliminate the

problem and restore proper operation.

If you are in doubt about some of the check points, or if the

remedies indicated in the chart do not solve the problem, refer to

the directory of Authorized Service Centers (enclosed with this

unit) to locate a convenient service center, or consult your dealer

for instructions.

Problem Probable cause(s)

Sound is not heard from

the center, surround or

subwoofer speakers.

The presence setting of the speaker has

been incorrectly set to “NONE” or “NO”.

While enjoying the surround sounds

¡Set the type and presence setting of each

speaker correctly.

Hiss is heard during

stereo broadcasts, but not

during monaural ones.

Excessive noise in both

stereo and monaural

broadcasts.

“STEREO” and “TUNED”

indicators flicker.

Stereo broadcasts highly

distorted.

Modulation for the two types is different so

some noise may be heard during stereo

broadcasts.

Antenna location and direction poor.

Station is distant.

Antenna location and direction poor.

Station is distant.

Building or mountain nearby.

¡Reduce the treble.

¡Change the location and direction of the

antenna.

¡Use an outdoor antenna.

¡Use an antenna with more elements.

12, 13

–

¡Change the location and direction of the

antenna.

¡Use an outdoor antenna.

¡Use an antenna with more elements.

Unusual “beat”sound is

heard.

Low-pitched “hum” is

heard when a station is

tuned.

A continuous or

intermittent hiss is heard.

A television is on nearby.

Adjacent signal is interfering.

AC mains lead is near the antenna wires.

Electronic interference from the AC mains

lead is fed to the speakers.

Interference from other appliances.

¡Separate the two or turn the television off.

¡Reduce the treble.

¡Separate the AC mains lead from the

wires.

¡Use an outdoor antenna.

¡Separate this unit from such appliances.

While listening to AM broadcasts

While listening to FM broadcasts

¡Select “VGCA ON”.

The DSP sound mode has been incorrectly

set to “STEREO”.

¡Set to SURROUND mode.

SURROUND and SFC

cannot be selected.

VGCA is ON. ¡Select “VGCA OFF”.

Page(s)

12, 13

–

17, 18

Cannot play Dolby Digital

or DTS sources.

The PCM FIX mode may be on.

An SFC mode is on.

SPEAKERS B is on. ¡Turn SPEAKERS B off. 22

¡Turn PCM FIX mode off.

¡Switch to SURROUND or STEREO mode.

The DTS FIX mode may be on. ¡Turn DTS FIX mode off. 21

An AM broadcast station

cannot be picked up clearly.

Frequency step is set to 10 kHz. ¡Hold down [BAND] for about 3 seconds.

This changes the frequency step to 9 kHz.

Suggested remedy

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Technics SA-DA8 Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Technics SA-DA8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info