Before recording
31
RQT5479
Selection of tapes for recording
The unit automatically identifies the type of tape.
Normal position/TYPE 1 ✔
High position/ TYPE 2 ✔
Metal position/ TYPE 4 ✔
To display the tape counter while recording
Press [COUNTER].
The counter is displayed for about five seconds.
A
Erasure prevention
The illustration shows how to remove the tabs to prevent recording.
To record on the tape again, cover as shown, being careful not to
cover the high position discrimination hole.
B
Volume and sound quality
Recordings are unaffected by changes to volume and sound
quality.
Preparatory steps
Do these steps before each recording.
Wind up the leader tape so recording can begin immediately
(unnecessary if CD editing).
1 Press [ OPEN/CLOSE], insert the
cassette with the tape facing in.
Make sure the cassette is fully inserted and press
[ OPEN/CLOSE] to close the deck.
2 Press [DOLBY NR] to select Dolby NR
on
(“
NR
” appears) or off.
(
a
“Dolby noise reduction” page 16).
3 Press [REV MODE] to select the
reverse mode.
Each time you press the button:
: One side only records.
and : Both sides record (forward → reverse).
“ ” automatically changes to “ ”
when [¡REC PAUSE] is pressed.
C
Erasing recordings
1. Press [INPUT SELECTOR] to select “TAPE”.
2. Press [DOLBY NR] so that “
NR
” goes off.
3. Select the reverse mode.
4. Press [¡REC PAUSE].
5. Press [v] or [u].
B
1
2
