> Use the arrow keys up/down to mark the additional win-
dow displayed: Type.
> Confirm by pressing OK. Awindow showing the timer types
available will be displayed.
> Use the arrow keys up/down to select the desired timer
type.
> To accept the timer type, confirm by pressing OK.
> When you have completed the programming, press the yel-
low function key Accept to accept the data into memory.
Please note!!!
Please ensure that the receiver has acquired the time. This will be
shown in the display while the unit is in stand-by mode. If this is not
the case, leave the receiver switched on to a major programme such
as ZDF for approximately 30 seconds, so that the receiver can acqui-
re the current time.
Now the time should be shown in the display while the receiver is in
stand-by mode (provided this was activated in Point 6.2.4).
8 Changing the basic programming
8.1 Configuring the Favourites list
This chapter describes how you can change the pre-programming of
your digital receiver as well as the Favourites programme list in
accordance with your own preferences. This function is also required
to sort newly found programmes into the programme list after a pro-
gramme scan has been performed.
In this regard you should know the following: your receiver is equip-
ped with two programme lists, the Favourites list and the Total
list. The Favourites programme list includes all the programmes you
have accepted into the list according to the procedure described
below. The Total list includes all programmes.
In addition, this chapter describes how you can delete programmes,
block access to programmes via the parental control function, or
accept programmes into the EPG. When calling up the programme
list via the OK key, the Favourites programme list will be displayed.
38
