Bedienungsanleitung Techno line WS6448 (Seite 4 von 24) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

801422

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

EN 1

WS 6448

LCD Screen and settings

Initial operation:

Open the battery compartment on the rear side of the outdoor remote sensor and insert 2x AAA batteries. Pay attention to

observe the correct polarity. Select the °C/°F display by pushing the button inside the compartment. Close in the battery

compartment.

Open the battery compartment on the rear side of the receiver and insert 2x AAA batteries. Pay attention to observe the

correct polarity. Close the battery compartment.

When you insert the batteries, the icons on the LCD display will light up for 3 seconds, and you will hear a beep tone, and

detect indoor temperature & humidity.

The receiver will now start to make a connection to the outdoor remote sensor. This operation takes about 3 minutes and

is displayed by a flashing reception antenna symbol in the “OUTDOOR” display area on the receiver.

After receiver has created a connection to the outdoor remote sensor, it will then enter the clock mode.

Receiving of the DCF signal:

After power on, the unit will automatically start to receive DCF signal for 7 minutes, and the reception icon flashes.

At 1:00 /2:00 / 3:00 am, DCF reception will be turned on automatically, and the clock will be synchronized if the reception

was successfull. If the reception fails (the radio mast icon disappears from the display), the system will automatically

attempt another synchronization at the next full hour. This procedure is repeated automatically up to total 5 times per day.

Press the “WAVE“ key to start the DCF reception manually. If no signal was received within 7 minutes, then the DCF

signal search stops (the radio mast icon disappears) and starts again at the next full hour.

Note:

A flashing radio mast icon indicates that the unit is searching DCF signal.

A continuously displayed radio mast icon indicates that the DCF signal was received successfully, the radio mast icon will

disappear if reception fails.

We recommend a minimum distance of 2.5 meters to all sources of interference, such as televisions or computer monitors

Radio reception is weaker in rooms with concrete walls (e.g.: in cellars). In such extreme circumstances, place the unit

close to the window.

Manual time setting:

Press and hold down the “MODE” button for 2 seconds, the Year display 2012 starts to flash. Now use “▲” and “▼”

buttons to set the correct year.

Press “MODE” to confirm your setting, the Month display starts to flash. Now use “▲” and “▼” buttons to set the correct

month.

Press “MODE” to confirm your setting, the Date display starts to flash. Now use “▲” and “▼“buttons to set the correct

date.

Weather

Outdoor today

temperature memory

Weekday

Date

Alarm icon

RCC icon

Time

Snooze icon

Indoor temperature

Indoor humidity

RF icon

Outdoor

temperature

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Techno line WS6448 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info