541944
5
Zoom out
Zoom in
Vorherige Seite
1/6
Nächste Seite
TIME SETTING
1. Press and hold the SET button for 2 seconds, hour digits flash. Press the or the button to
set the hours.
2. Then pressthe
SET
button again, the minute digits flash. Press the or the button to set the minutes.
3. Then press the SET button again, display shows 05 and flash. Press the or the button to
set snooze duration from 5 minutes to 60 minutes.
4. Then press the SET button again, display shows 00 and flash. Press the or the button to
set the time zone:
-01” GMT +0 (United Kingdom)
“00” GMT +1 (Central Europaen time)
“01” GMT +2 (Eastern Europaen time)
Note: Time zone can only set when the clock successfully receives a radio signal.
5. Press the SET button again to store the settings and return to normal time display. The clock
will return to normal mode in around 10 seconds if no further press of any other buttons.
Note: The time is displayed in 24-hour display format.
ALARM SETTING
(default alarm setting is 6:00 AM)
1. Press and hold the ALM button until the AL icon appears on the display, the hour digits flash.
Press the or the button to set the desired alarm hours.
2. Press the ALM button again, the minute digits flash. Press the or the button to set the
desired alarm minutes.
3. Press the ALM button again to store the alarm settings and return to normal time display. The
clock will return to normal mode in around 10 seconds if no further press of any other buttons.
To turn on or off the alarm
Single press the ALM button during normal time display to turn on or off the alarm. When the alarm
function is turned on the AL icon appears on top of the time digits.
Note: Alarm duration is 2 minutes.
To use the snooze function
When time reaches the set alarm time, the station will give a beep sound to wake you up. The AL
icon will flash.
1. Press SNOOZE once to stop the alarm temporarily, AL icon keeps flashing. The alarm will
beep again after the set snooze duration.
2. To stop the daily alarm, press any button except the SNOOZE button when alarm is beeping.
The alarm will stop and
AL
icon becomes static. The Alarm will beep again same time next day.
DIMMER FUNCTION
Press the SNOOZE / DIMMER button to adjust high or low brightness of the LED display.
TROUBLE SHOOTING
In case the station shows false digits, it maybe affected by electrostatic discharge or interferences
from other devices. Press the RESET button on the back of the station. The station will be reset to
default setting of time and calendar and it will start to receive radio controlled time signal again.
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

techno-line-ws6825

Suche zurücksetzen

  • WS6825 zeigt falsche Außentemperatur an. Neu eingestellt nach Bedienungsanleitung, weiterhin falsche Temperatur, Zeit 16 Grad plus, tatsächlich aber minus 3 Grad
    Eingereicht am 14-12-2022 16:07

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Techno line WS6825 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Techno line WS6825

Techno line WS6825 Bedienungsanleitung - Deutsch - 6 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info