35
Crossover
cont.
Switching on and off
To turn 700 and 500 versions of the equipment on, switch the switch to “I”
position.
To turn the 700 SP and 500 SP versions on, begin moving.
When switched on, a beep sounds and all the control panel LEDs light up.
After a quick system check (reset), the equipment is ready for use.
The message does not appear if the keys are disabled (see the Configuration Menu section in the software part) so that
exercises can be started only with the TGS key
The message does not appear if the TGS key reader is not installed or if the use of the TGS key is disabled (see the Configuration
Menu section in the software part) so that exercises can be started only with the control panel keys.
In this mode, the following functions are enabled:
- calculation of heart rate, if measured;
- reading of access codes for configuration menu (see the Configuration Menu section in the software part).
