Bedienungsanleitung Tefal DU4120 - Intense Dry Control (Seite 13 von 57) (Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

725071

Zoom out

Zoom in

Vorherige Seite

1/57

Nächste Seite

Your appliance is programmed for continuous start-up but, at your convenience, you can also select:

- The speed (button C)

- The target humidity rate (button B)

And on models DU4116/DH4120/DU4120 and DH4130/DU4130:

- The drying clothes function (button D)

- The Swing function (button E)

The indicator light (G) will be lit up awaiting automatic operation of the appliance.

PLEASE NOTE: the appliance will regulate itself automatically to maintain the target humidity rate

during the period of operation.

If you wish to exit the program, select “00 H” or start the appliance with button A; the light will switch off.

• DRY Function for Drying clothes (Mod DU4116/DH4120/DU4120 &

DH4130/DU4130)

Press the DRY (D) button to start the clothes drying function.

Continuous dehumidification and swing of the air outlet vent will start up automatically for

enhanced clothes drying.

• SWING Function (Mod DU4116/DH4120/DU4120 & DH4130/DU4130)

Press the “SWING" button (E): the air outlet vent will automatically swing, providing enhanced

distribution of dry air around the room.

• DEFROSTING INDICATOR LIGHT

If light (I) comes on, the dehumidifier is in defrosting mode. The compressor shuts down and will

start up again automatically after the defrosting phase.

NOTE: Check that the pre-filter is clean.

• FULL indicator light

The appliance beeps and the indicator (H) flashes when the tank is full or incorrectly positioned. The

indicator stops flashing and the dehumidifier starts up again once the tank is emptied and replaced.

• FILTER

It is essential to switch off your appliance using button (A) and to unplug it before any operation.

- Your appliance is fitted with a removable cleanable pre-filter/nano which must be cleaned regularly.

- Remove the pre-filter/nano (Fig.3 - Safety instructions) and clean it with a vacuum cleaner.

- Re-fit the pre-filter/nano (Fig.4-5 - Safety instructions).

- Never use the appliance without its pre-filter/nano.

• EMPTYING THE TANK

It is essential to switch off your appliance using button (A) and to unplug it before any operation.

When the tank is full:

- The appliance shuts down and the red FULL indicator light (H) comes on

- Remove the tank gently from the appliance (Fig.6 - Safety instructions), empty the water and put

the tank back into the appliance.

The red FULL indicator light (H) should switch off in a few seconds.

• CONTINUOUS DRAINAGE (see Fig 7 - Safety instructions).

It is essential to switch off your appliance using button (A) and to unplug it before any operation.

Use a PVC pipe, 12 mm in diameter (the 12mm diameter is the internal diameter of the hose).

1800134588-01_DH41_USER_8L.qxp_1800134588/01 21/04/15 10:52 Page13

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tefal DU4120 - Intense Dry Control Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info