Bedienungsanleitung Tefal PU6075 - Intense Pure Air XL (Seite 9 von 18) (Englisch)

724971

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

Ionizer function

The ionizer function releases negative ions into the air. This function is switched off by default. To activate it,

briefly press button 10.

Timer / delayed start

If the appliance is on: you can use this button to define the operating duration. Briefly press the button to select

the number of operating hours desired (1, 2, 4 or 8) and the appliance will automatically turn off at the end of

the selected period.

If the appliance is off: briefly press the button to set the appliance to turn on in a certain number of hours (1, 2, 4 or

8).

3D pure air function (adjustable grid)

You can adjust the position of the air outlet grid manually, as desired. For an optimum, even flow of purified air

in the room, set the angle to 45°; for maximum comfort, set the angle to 90°.

Control Panel Lock

The lock system prevents the purifier from being accidentally mis-set during operation.

To activate it, press the button (7) for 3 sec until the locked control panel indicator turns on. To exit this mode,

press the button (7) again for 3 seconds, until the indicator turns off. When selected, the other buttons are locked.

Always switch the appliance off with the button (9) and unplug it before conducting any maintenance

operation.

You can clean the appliance with a slightly damp cloth.

IMPORTANT: Never use abrasive products which could damage your appliance’s appearance.

Filters

This data is based on an average use of around 8 hours per day at lowest speed of Auto Day Mode.

The recommended frequency for cleaning and replacing the filters may vary depending on the duration of use

and the operating environment.

- The light indicates when the pre-filter needs cleaning.

- The light indicates when the active carbon filter needs replacing.

- The light indicates when the HEPA filter needs replacing.

- The light indicates when the color of the NanoCaptur filter needs checking.

• The NanoCaptur filter contains translucent granules which change color according to the formaldehyde absorption

rate. Refer to the color chart on the inside of the panel or the filter itself to establish the filter saturation rate. Once the

saturation rate has reached its maximum, the filter must be replaced. You have to check the filter saturation rate every

six months.

• The pre-filter can be re-used: remove the dust using a vacuum cleaner or wash with water.

CAUTION:

The appliance's efficiency can be reduced if the pre-filter is not cleaned regularly.

Never use a pre-filter that is still damp.

MAINTENANCE

Filter Action Cycles

Pre-filter Clean Every 2 to 4 weeks

Active carbon filter Replace Every 12 months

HEPA filter Replace Every 3 years

NanoCaptur filter Replace

Color changing

(see Color chart on filter)

TE_PURIFICATEUR_PU6075K0_1800143831_01.qxp_1800143831/01 02/06/2017 13:41 Page9

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tefal PU6075 - Intense Pure Air XL Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info