723224
13
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
15
EN
3.2 Microfilter (12)
Open the motor protection grid (11) - fig. 33a.
Separate the microfilter * (12) from the motor protection grid (11) - fig.33b.
Discard the microfilter* (12) into a dustbin - fig. 33c and replace it with a new microfilter (ref. RS-RT900037).
Place the new microfilter * (12) on the motor protection grid (11) - fig.33d.
Place the pins of the protection grid (11) in the notches on the dust compartment housing (7) - fig. 33d.
Lock the motor protection grid (11) - fig. 33e.
Make sure the microfilter* (12) and the protective grid (11) are properly in position before closing the lid (8).
Cleaning the vacuum cleaner
Wipe the body of the vacuum cleaner and accessories with a soft damp cloth, then dry.
Wipe the lid with a dry cloth- fig. 34.
Do not use detergents or any corrosive or abrasive products.
Important: As soon as your vacuum cleaner stops performing efficiently, and before making any checks, stop
it by pressing on the On/Off pedal.
If your vacuum cleaner does not start
The appliance is not powered: make sure the appliance is properly connected.
If your vacuum cleaner has no suction
An accessory or the hose (19) is blocked: unblock the accessory or the hose (19).
Ensure that the dust compartment (13) is properly mounted and present.
The lid is not properly closed: check that the dust compartment (13) is properly in position and close the lid (8).
If your vacuum cleaner suction is not working properly or is making a whistling
noise
An accessory or the hose is partially blocked: unblock the accessory or the hose (19).
The dust compartment is full: empty it (see CLEANING AND MAINTENANCE chapter).
The filtration system is saturated: clean the HEPA filter capsule (14) (see CLEANING AND MAINTENANCE
chapter).
If the problem persists, change the filtration system (see the CLEANING AND MAINTENANCE chapter).
The electronic power regulator (3) is set at minimum: increase the power using the electronic power regulator
(unless you are cleaning fragile fabrics).
The mechanical power regulator is open: close the mechanical power regulator on the power nozzle - fig. 9.
Ensure that the dust compartment (13) is well properly positioned in the dust tray housing (7).
If the lid does not close
Ensure that the dust compartment (13) is well properly positioned in the dust tray housing (7).
If the suction attachment is difficult to move
Open the mechanical power regulator on the power nozzle or decrease power - fig. 9.
Ensure that the position (brush retracted / brush out) of the suction attachment (22) corresponds to the surface
being cleaned.
If the power cord does not wind up completely
The cord slowed down as it was winding up: bring the cord back out and press the cord winder pedal (4) again.
If your vacuum cleaner stops while in operation
6. TROUBLESHOOTING
* According to model: these systems are specific to certain models or are accessories available as an option.
TE_ASPIRATEUR_COMPACTEO_ERGO_CYCLONIC_903086-01_903086 03/05/12 16:36 Page15
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Tefal TW5376 - Compacteo Ergo wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info