688826
16
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
TIG 3000 B
Vers. 001
16
GB
(Normally Open) type, emergency stop button.
When the contact is closed (emergency button
pressed), the generator will stop immediately
and power is cut from its electronic circuits.
5.8 Connection to the fuel tank
The generator can be connected to the vehicle’s
fuel tank (provided it uses the same type of fuel).
In this instance the generator must be supplied
by a circuit fitted with independent fuel pick up
and return. It is absolutely imperative that the
generator’s fuel line is not connected to that of
the vehicle’s engine, as this could result in seri-
ous malfunctions and invalidate the warranties of
both.
For the connection to the fuel tank use only fuel
grade tubing of a suitable diameter.
Make sure that the cross-section of the tubes is
not reduced by choking, bending or squashing.
Available options are a fuel tank equipped with a
filler that can be fitted to the side of the vehicle
(code 05466) and another with only a cap (code
05472), both of about 15 litres capacity, which
can be positioned either vertically or horizontally,
fitted with a tap with a reserve indicator.
When choosing the position in which to install the
fuel tank, ensure that the fuel line length is as
short as possible.
Position the fuel tank away from sources of heat
and in a location protected from external water.
The level of the tank must differ by no more than
20 cm from that of the generator. If the fuel tank
is installed at a level that is 0.5 m lower than that
of the generator, it may be necessary to install an
additional fuel pump.
An optional electric pump (code 00507) is avail-
able that can easily handle differences in levels
greater than one metre.
5.9 Connecting two TIG3000B units in
parallel
Should it be necessary to double the available
power, it is possible to connect two TIG3000B
units in parallel (they must have the same or
compatible hardware and software revision lev-
els). The connection must be carried out follow-
ing the wiring diagram at Fig. 25.
1 = TIG 3000B #1
2 = TIG 3000B #2
3 = Battery (may be common)
4 = Data cable for parallel connection
5 = TIG #1 230 V output cable
6 = TIG #2 230 V output cable
7 = Connection point of the two outputs
8 = Load connection
The following rules must be observed when car-
rying out the parallel connection:
- the connections must be made with the genera-
tors switched off
- the maximum distance between the two genera-
tors must not exceed 10 metres
- the length of cables 5 and 6 from the outputs of
the generators to the junction point must be less
than 15 metres each, the lengths must be identi-
cal (a maximum difference of 1 metre is tolerat-
ed) and the wires must be of the same size
- make absolutely certain that the N, L and PE
connections to the user circuit are correct
- the two generators may share the same starter
battery or each may have its own
- with regard to the size of the cables used, com-
ply with the specifications in the paragraph on
electrical connections
If these rules are not complied with the overall
power output will not equate to the sum of the
outputs of the two generators, or worse still,
might create a malfunction with damage to the
generators.
In order for the two generators to be able to work
with the outputs connected in parallel, they need
to exchange data on the synchronisation and op-
eration. This is achieved through the special (op-
tional) data cable code 06688 (Fig. 25 ref. 4).
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Telair TIG3000B Inverter generator wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Telair TIG3000B Inverter generator

Telair TIG3000B Inverter generator Bedienungsanleitung - Holländisch - 44 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info