Bedienungsanleitung Telair TIG3000D Inverter generator (Seite 16 von 48) (Englisch)

688827

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

TIG 3000 D

Vers. 002

lock"). This wire is live with +12 V voltage

when the vehicle engine is running. The in-

formation is used by the generator to stop at

each change of state of D+.

• REMOTE On-Off connector (fig. 22 ref. 4): this

connector can be used to connect the two

poles of a galvanically isolated open-closed

contact, (for example, the contact of an elec-

tromechanical relay), controlled by a remote

device. When the contact is closed, the gen-

erator will start and it will stop when the con-

tact is opened.

• EPO connector (Fig. 22 ref. 5): this connector

can be used to connect the two galvanically

isolated poles of the contact of a remote NO

(Normally Open) type, emergency stop button.

When the contact is closed (emergency button

pressed), the generator will stop immediately

and power is cut from its electronic circuits.

5.8 Connection to the fuel tank

The generator can be connected to the vehicle’s

fuel tank (provided it uses the same type of fuel).

In this instance the generator must be supplied

by a circuit fitted with independent fuel pick up

and return. It is absolutely imperative that the

generator’s fuel lines are not connected to those

of the vehicle’s engine, as this could result in se-

rious malfunctions and invalidate the warranties

of both.

For the connection to the fuel tank use only fuel

grade tubing of a suitable diameter.

Make sure that the cross-section of the tubes is

not reduced by choking, bending or squashing.

Available options are a fuel tank equipped with a

filler that can be fitted to the side of the vehicle

(code 05466) and another with only a cap (code

05472), both of about 15 litres capacity, which

can be positioned either vertically or horizontally,

fitted with a tap with a reserve indicator.

When choosing the position in which to install the

fuel tank, ensure that the fuel line length is as

short as possible.

Position the fuel tank away from sources of heat

and in a location protected from external water.

The level of the tank must differ by no more than

20 cm from that of the generator. If the fuel tank

is installed at a level much lower than that of the

generator, it may be necessary to install an addi-

tional fuel pump.

An optional electric pump (code 00507) is avail-

able that can easily handle differences in levels

greater than one metre.

For the electrical connections for the additional

pump and the fuel reserve indicator, please see

the paragraph on auxiliary connections.

5.9 Connecting two TIG3000D units in

parallel

Should it be necessary to double the available

power, it is possible to connect two TIG3000D

units in parallel (they must have the same or

compatible hardware and software revision lev-

els). The connection must be carried out follow-

ing the wiring diagram at Fig. 25.

1 = TIG 3000D #1

2 = TIG 3000D #2

3 = Battery (may be common)

4 = Data cable for parallel connection

5 = TIG #1 230 V output cable

6 = TIG #2 230 V output cable

7 = Connection point of the two outputs

8 = Load connection

The following rules must be observed when car-

rying out the parallel connection:

- the connections must be made with the genera-

tors switched off

- the maximum distance between the two genera-

tors must not exceed 10 metres

- the length of cables 5 and 6 from the outputs of

the generators to the junction point must be less

than 15 metres each, the lengths must be identi-

cal (a maximum difference of 1 metre is tolerat-

ed) and the wires must be of the same size

- make absolutely certain that the N, L and PE

connections to the user circuit are correct

- the two generators may share the same starter

battery or each may have its own

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Telair TIG3000D Inverter generator Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Telair TIG3000D Inverter generator

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info