44
Connections and Assemblig
Connecting TV via aerial cable (if you are not using a RCA cable)
■ If you are using a RCA cable, select the RCA (AV) input on the TV to see the picture from the player.
■ If you are not using a RCA cable, select the button number on the TV reserved for the VCR-DVD player.
If you are not using a RCA cable, your player can transmit pictures and sound to the TV via the coax aerial cable. Just
tune the TV to the player's transmitting channel (factory set to UHF channel 36). Tune the TV carefully to ensure the
best pictures and sound.
Once you have carried out the steps in "Connecting
up the player" , switch on your TV.
Press the [OK] button of the player’s remote control
longer than 5 seconds to call the player´s test
picture.
Tune the TV to the test picture using the channel pre-
set functions of your TV as described in its manual.
When you have found the test picture, store it under
the button number on your TV for player input.
Press the [OK] button of the player’s remote control
again longer than 5 seconds to release the test
picture.
1
• If the quality of the test picture transmitted to the TV is
poor due to interference caused by a station
transmitting on channel 36, you can change the
player RF output to a different transmitting channel.
While the 'RF 36' (or whatever) is showing on the
front display, type in a free transmission channel
number between 27 and 69, then re-tune your
television to it so you see the test picture again.
Press the OK button until the 'RF' number and the test
picture go off.
You can also change the RF output channel through
the set-up menu, providing you can see it clearly ! To
do this, press [SETUP], select "VCR SETUP" and press
[OK]. Then select "RF OUTPUT SET" and press [OK].
Type in a free channel and re-tune the TV so you see
the RF OUTPUT menu again.
Of course, you might not know a free channel, but
you can experiment. You can also do this the other
way round if your TV lets you type a transmission
channel number into its tuning set-up menu.
2
• If the quality of the test picture transmitted to the TV is poor, fine-tuning on the TV may help
(refer to the TV manual).
• Without a RCA cable, you will not get stereo sound from a TV capable of stereo sound.
RF OUTPUT SET
0-9:SELECT (27-69)
OK:CONFIRM SETUP:END
CH 36
CHECK IT!
DV6T714D-RG1H(TDV6000)2 02.8.12 10:38 AM ˘ ` 44 mac001 300DPI 120LPI
