Bedienungsanleitung Telstra 6100A (Seite 3 von 15) (Englisch)

628341

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

Getting started

Location

You need to place your Telstra 6100/6100a close enough to a mains power and telephone socket so that

the cables will reach. Make sure it is at least 1 metre away from other electrical appliances to avoid

interference.

WARNING Do not place your Telstra 6100a in the bathroom or other humid areas.

Your Telstra 6100/6100a works by sending radio signals between the handset and base. The strength of

the signal depends on where you site the base. Putting it as high as possible can help to provide the best

signal

Handset range The handset reception range from the base is up to 300m outdoors and up to 50m indoors.

Thick walls can severely affect the range.

Range indicator The symbol on your handset display indicates when you are in range of the base. If the

symbol flashes and you hear a warning beep, you are out of range and will need to move closer to the base.

Setting up

1. Plug the mains power cable into the base. Then plug the power adaptor into the mains wall socket

and switch the power on. The light on the base lights up.

IMPORTANT Do not connect the telephone line until the handset(s) is fully charged. The base must be plugged

into the mains power at all times.

Which socket? Power socket Telephone line socket

Getting started

2. Remove the battery compartment cover and insert the 2 x AAA NiMH batteries supplied into the

handset. Slide the battery compartment cover back into place.

3. Charge the handset for at least 16 hours by placing it on the base. The charging indicator light on

the base comes on. The screen will show the standby display and a scrolling battery icon to show

that the handset is charging.

4. After 16 hours, plug the telephone line cord into your Telstra6100/6100a base unit and the other end

into the wall socket.

6SXO-Y\N

Your Telstra 6100/6100a is now ready for use.

Battery performance When batteries are fully charged the display shows the battery is full. To keep your batteries

in the best conditions, leave the handset off the base for a few hours at a time (after the initial 16 hour charge).

Please note however, that new NiMH batteries do not reach full capacity until they have been in normal use for

several days. Running the batteries right down at least once a week will help them last as long as possible. The

charge capacity of rechargeable batteries will reduce with time as they wear out, so reducing the talk/standby

time of the handset. Eventually they will need to be replaced. New batteries can be obtained from TecHelp on

1300 369 193 or your local electrical retailer.

Battery low warning When the battery charge is low the handset battery icon will show empty.

Place the handset back on the base to recharge.

Replacing batteries Use only rechargeable 750mAh or higher AAA NiMH batteries.

Talk/Standby time Under ideal conditions, fully charged handset batteries should give up to 10 hours

talk time or 100 hours standby on a single charge.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Telstra 6100A Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info