649682

Telwin DOCTOR CHARGE 50 Seite 6

6
Zoom out
Zoom in
Vorherige Seite
1/164
Nächste Seite
- 6 -
EN
1. GENERAL SAFETY RULES FOR THE USE
- Avoidcontactwithbatteryacid.Shouldanoperator
be sprayed or come into contact with the acid, rinse
therelativeparts immediatelyundercleanrunning
water. Continue to rinse the area until the physician
arrives.
- During the charge the battery produces explosive
gases,avoid the formationof ames andsparkes.
DO NOT SMOKE.
- Position the batteries to be charged in a well-
ventilatedplace.
- Protect the eyes. Always wear protective goggles
when using acid lead accumulators.
- Always wear suitable clothing. Never wear baggy
clothing or jewellery that can get caught up in
moving parts. During all operations, electrically
insulated protection clothing and non-slip boots
must be worn at all times. Persons with long hair
must tie it back and wear a hair net.
- Inexperience and untrained people should be
properly instructed before using the appliance.
- People (children included) whose physical, sensory
ormentalcapacitieswouldpreventthemfromusing
the appliance correctly must be supervised by a
person who is responsible for their safety while the
appliance is in use.
- Childrenmustbesupervisedtoensurethattheydo
not play with the appliance.
- Use the battery charger only indoors and make sure
that you start it in airy places. DO NOT SET IN THE
RAIN OR SNOW.
- Disconnect the mains cable before connecting to or
disconnecting the charging cables from the battery.
- Do not connect or disconnect the clamps to or from
the battery with the battery charger operating.
- Neverusethebatterychargerinsidethecarorinthe
bonnet.
- Substitute the mains cable only with an original one.
- Do not use the battery charger to charge batteries
which are not rechargeable.
- Make sure the available power supply voltage
corresponds to that shown on the battery charger
rating plate.
- To prevent damaging the vehicle electronics,
scrupulously respect the warnings given by the
producerofthevehicleorthebatteriesused.
- This battery charger has components such as
switches and relays which can cause arcs or sparks.
Therefore when using it in a garage or in a similar
place set the battery charger in a suitable case.
- Repair or maintenance of the inside of the battery
charger can be executed only by skilled technicians.
- WARNING: ALWAYS DISCONNECT THE POWER
SUPPLY CABLE FROM THE MAINS BEFORE
CARRYING OUT ANY SIMPLE MAINTENANCE
OPERATION ON THE BATTERY CHARGER.
- The battery charger is protected from indirect
contact by an earth wire as indicated for class I
equipment. Make sure the power outlet is protected
by an earth connection.
- In models without this element, connect plugs
of appropriate capacity, not below the fuse value
indicated on the rating plate.
- ClassAdevice:
This battery charger complies with the requirements
of the technical standard for products to be used
in industrial environments and for professional
purposes. No compliance with the electromagnetic
compatibility in domestic use buildings is guaranteed
andthose connecteddirectly to alow voltagepower
supply network that furnishes buildings designated to
domestic use.
2. GENERAL DESCRIPTION
Battery charger indicated for charging WET, GEL, AGM,
PbCa lead batteries used by motorised vehicles (petrol and
diesel) and electric vehicles: automobiles, motor vehicles,
motorcycles, boats, etc. It is possible to charge 6V, 12V and
24V batteries; the 50 model also has a starter aid mode (for
vehicles with petrol and diesel engines only).
3. INSTALLATION
3.1 BATTERY CHARGER POSITION
When running, position the battery charger in a stable
position and make sure the air ow through the openings
which guarantee required ventilation is not blocked.
3.2 CONNECTION TO THE MAINS
- The battery charger must only be connected to a power
supply system with neutral conductor connected to
earth.
- Check that the mains voltage is the same as the battery
charger voltage indicated on the rating plate.
- The power line must have a protection system, such as
fuses or circuit breakers, that can support the maximum
apparatus absorption.
- Use the relative power cable when connecting to the
mains.
- Any power cable extensions must be of suitable section
size, never lower than that of the supplied power cable.
- It is always compulsory to connect the device to the
grounding system, using the yellow-green wire in the
power cable identied with the label (
), whilst the other
two wires must be connected to the phase and neutral
conductors on the mains power supply.
4. OPERATING DURING CHARGING
N.B.: Before charging, make sure the capacity (Ah)
of the battery to be charged is not lower than that
indicated on the battery charger rating plate (Cmin).
Followtheinstructionsscrupulouslyintheordergiven
below.
4.1 BATTERY PREPARATION
If the battery to be charged is the WET type, the procedure
is as follows:
- Remove the battery caps (if present), so that the gas
produced during charging can exit. Make sure the level
of electrolyte covers the battery plates; if they are not
covered, add distilled water until they are submerged by
5-10 mm.
ATTENTION! BE VERY CAREFUL WHILE
CARRYING OUT THIS OPERATION BECAUSE
THE ELECTROLYTE IS AN EXTREMELY
CORROSIVE ACID.
4.2 BATTERY CHARGER/BATTERY CONNECTION
- Check that the power cable plug has been disconnected
from the mains socket.
- Connect the red charging clamp to the positive battery
The documentation can be downloaded in PDF version from
the link: www.telwin.com/usermanual
… 6 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

telwin-doctor-charge-50

Suche zurücksetzen

  • Das Gerät ist am blinken und zeigt A.05 an was muß ich tun Eingereicht am 4-6-2024 21:03

    Antworten Frage melden

  • Ich habe Ladegerät angeschlossen zur Autobatterie und eingeschaltet,aber es blinkt LCC. Was bedeutet das? Eingereicht am 11-10-2021 14:27

    Antworten Frage melden

    • LCC steht für Limit Charge Current, also begrenzter Ladestrom. Es ist eine Schutzfunktion für tiefentladene Batterien. Sobald die Batteriespannung einen bestimmten Schwellenwert überschreitet, wird wieder mit eingestellter Stromstärke geladen. Beantwortet 23-7-2024 04:17

      Finden Sie diese Antwort hilfreich? Antwort melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Telwin DOCTOR CHARGE 50 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info