Bedienungsanleitung Telwin ENERGY 650 START (Seite 3 von 52) (Alle Sprachen)

627239

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

low values according to the capacity and condition of the

5. BATTERY CHARGER PROTECTIONS (FIG. D)

battery.

The battery charger is equipped with protection in case of:

FIG.B

- Overloads (too much current delivered towards the

battery).

NOTE: Once the battery is charged you may note the liquid

- Short circuit (charging clamps set in contact with one

inside the battery starting to “boil”. It is advisable to stop

another).

charging when this phenomenon appears so as to prevent

- Polarity reversal of the battery.

damage to the battery.

- For battery chargers equipped with fuses, it is necessary,

in case of substitution of fuses, to use spares having the

By means of the switch, select the charge current according

same nominal current value as the fuse changed.

to the type of battery and its charge condition. This value is

WARNING: If fuses with current values different

shown by the ammeter on the scale with the lower value.

Note that slow charging is the best guarantee for longer

from those given were used damages to persons and

battery life as there is less heating, thus preventing plate

things could be caused. For the same reason do not

oxidation and electrolyte boiling.

substitute the fuse with copper (or other materials)

The ideal current value is 1/10 the ampere-hour power of the

bridge.

battery. For example, for a 40 Amp battery the optimum

The substitution of the fuses is to be done when the

charge current is 4 Amps.

mains cable is disconnected from the mains.

Simultaneous charging of several batteries

6. USEFUL ADVICE

This operation must be performed with great caution:

- Clean the positive and negative terminals of possible

WARNING; do not simultaneously charge different types of

oxidation so as to ensure good contact with the clamps.

batteries or batteries with different capacities or levels of

- Never ever allow the two clamps to come into contact

discharge.

when the battery charger is plugged into the mains. If you

If you have to charge more than one battery at the same time

do the fuse will blow.

you can connect them “in series” or “in parallel”. Between the

- If the battery charger is used with a battery which is

two systems, we recommend connection in series because

always connected to a vehicle, check the instruction

you can easily check the current charging each battery, as it

and/or maintenance manual of the vehicle under the

will be the same as that shown by the ammeter.

paragraph: “ELECTRIC SYSTEM” or “MAINTENANCE”.

Before charging it is advisable to disconnect the positive

NOTE: If two batteries with rated voltages of 12V are

cable which is part of the electrical system of the vehicle.

connected in series, the battery charger MUST be set to the

- Check the battery voltage before connecting it to the

24V position.

battery charger. Remember that 3 caps correspond to a 6

FIG. C

volt battery, while 6 caps to a 12 volt battery. At times you

may have two 12 volt batteries. Sometimes there may be

END OF CHARGE

two 12Volt batteries in series, in which case a voltage of

- Remove the power supply from the battery charger by

24Volt is required to charge both accumulators. Make

turning the switch to OFF (if present) and/or removing the

sure they have the same specifications to prevent uneven

power supply cable from the mains outlet.

charging.

- Disconnect the black charge clamp from the chassis of

- Before proceeding with starting, carry out a rapid charge

the vehicle or from the negative terminal of the battery (-

for a few minutes: this will limit the starting current, hence

symbol).

also requiring less mains current. Before starting the

- Disconnect the red charge clamp from the positive

vehicle, remember to make sure the battery is connected

terminal of the battery (+ symbol).

properly to the respective (+ and -) terminals, and that it is

- Store the battery charger in a dry place.

in good condition (not sulphated or dud).

- Close up the battery cells with the appropriate plugs (if

Never ever start vehicles with the batteries disconnected

present).

from their respective terminals; the presence of the

battery is essential for the elimination of possible

STARTING

overvoltage that may be generated due to energy

Before starting the vehicle, make sure the battery is

accumulating in the connection cables at the starting

connected properly to the respective (+ and -) terminals,

stage.

and that it is in good condition (not sulphated or dud).

- If the engine does not start, do not insist, but wait a few

Never ever start vehicles with the batteries

minutes and then repeat the rapid charge operation.

- Starting should always be carried out with the battery

disconnected from their respective terminals; the

connected (see the section on STARTING).

presence of the battery is essential for the elimination of

possible overvoltage that may be generated due to

energy accumulating in the connection cables at the

_______________( I )_______________

starting stage.

For starting turn the switch to the start position at the voltage

MANUALE D’ISTRUZIONE

corresponding to that of the vehicle being started.

It is essential, before turning the ignition key, to make a rapid

charge for 5-10 seconds, which will greatly facilitate starting.

Rapid charging should always be done with the battery

charger switched to the charge position and NOT to

AT T E N Z I O N E : P R I M A D I U T I L I Z Z A R E I L

starting.

CARICABATTERIE LEGGERE ATTENTAMENTE IL

It is possible to enable starting by pressing the remote control

MANUALE D’ ISTRUZIONE!

button (only for 3-phase).

The current supplied is indicated on the scale of the ammeter

1. SICUREZZA GENERALE PER L'USO DI QUESTO

with greater capacity.

CARICABATTERIE

WARNING: Before proceeding with starting follow the

vehicle manufacturer's instructions carefully!

- Make sure the power line is protected by fuses or

- Durante la carica le batterie emanano gas esplosivi,

automatic circuit-breakers with sizes as indicated on the

evitate che si formino fiamme e scintille. NON FUMARE.

rating plate by the ( ) symbol.

- Posizionare le batterie in carica in un luogo areato.

- In order to prevent overheating in the battery charger,

ALWAYS carry out the starting operation according to the

duty cycle (work/pause) as indicated on the appliance (e.g.

START 3s ON 120s OFF-5 CYCLES). Do not insist if the

engine does not start: this could cause serious damage to

- L e p e r s o n e i n e s p e r t e d ev o n o e s s e r e

the battery or even to the electrical equipment in the

opportunamente istruite prima di utilizzare

vehicle.

l'apparecchio.

- 3 -

Telwin ENERGY 650 START Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info