649707

Telwin START PLUS 6824 Seite 4

4
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
4
WARNING:DANGER!
Connect the mounting socket (Fig. A-1) to the starter’s
12V or 24V power supply, checking the voltage
required for the vehicle to be started, and only after
being absolutely certain that the clamps have been
connected to the battery polarities correctly.
- Connect the mounting socket following the instructions
above.
- Turn the ignition switch or key of the vehicle or boat to
ON. Wait about one minute. Turn the vehicle ignition
switch or key to the start position for no more than 5÷6
seconds. If the vehicle or boat does not start, wait at
least 3 minutes before trying again.
Warning: Do not allow the black and red
clamps to come into contact with each other
or to touch a common conductor.
- Whilst the engine is running, disconnect the mounting
socket from the starter and the clamps from the vehicle
in the exact order seen below:
1. the mounting socket.
2. the black (negative) clamp.
3. the red (positive) clamp.
- Return the clamps to their housing on the starter.
It is highly recommended to recharge the starter as
soon as possible!
Using the starter as a 12V power supply unit by
means of the cigar-lighter type socket (Fig. A-4).
WARNING!12VOUTPUTONLY!
In case of overload the re-settable safety
switch will trip. To restore operation, remove
the cause of overload and press the button shown
in Fig.A-2.
- Take the cover off the cigar-lighter type socket (Fig.
A-4).
- Insert the cigar-lighter plug of the device to be powered
into the socket (Fig. A-4).
Recharging using a 230V AC power supply
Important! To protect the battery and lengthen
its working life, charge it for 12 hours before
usingitforthersttime,thenaftereverytime
it is used and, in any case, at least every 3 months.
It is possible to recharge the unit using the 230V AC
power adapter supplied. We recommend keeping the
battery fully charged at all times. A low charge level could
shorten the life of the battery. Bear in mind that the time
needed to recharge the battery depends on the number
of times it has been used. It is possible to check whether
the battery level is low by pressing the red button (Fig.
A-5).
The voltmeter (Fig. A-3) will indicate the battery charge
level. The green area of the voltmeter indicates that the
battery is charged.
Recharging
1- Connect the free starter plug at POSITION 12V,
making sure that the starter clamps are positioned in
the relative pocket and insulated from each other.
2- Insert the car cigarette lighter plug supplied with the
battery charger into the starter outlet (Fig. A-4).
3- Insert the battery charger plug into a 230 V socket.
4- Allow the starter to recharge for as long as necessary
(refer to the battery charger user manual).
5- When charging is nished remove the battery
charger and disconnect the free starter plug from
POSITION 12V.
Pb
DISPOSING OF THE BATTERY
When the starter battery is completely run down it should
be taken to a re-cycling depot. In some countries this is
mandatory. Contact the local special refuse authority for
information on recycling.
WARNING: Do not burn the battery to dispose of it.
This could cause an explosion. Before disposing of the
battery, apply insulating tape to the bare terminals to
prevent shorting. Do not expose the battery to intense
heat or re as this could cause an explosion.
STARTER SPECIFICATIONS “4824”
Typeofbattery:
- rechargeable factory-sealed 12V acid-lead batteries.
Batterycapacity:
- 40Ah.
Outputcurrent@24V:
- 2200A peak current;
- 800A starter current.
Outputcurrent@12V:
- 4400A peak current;
- 1600A starter current.
Coppercables:
- PVC insulated 16mm
2.
Cablelength:
- 190cm.
Outputsocket:
- 12V DC / max. current 10A.
Generalfeatures:
- re-settable safety switch for output overload;
- automatic charging level reset switch;
- “cigar-lighter” type socket, 12V DC.
Weight:
- 24kg.
Standardaccessories:
-
T-CHARGE 12 Power supply / Battery charger (Fig. B).
STARTER SPECIFICATIONS “6824”
Typeofbattery:
- rechargeable factory-sealed 12V acid-lead batteries.
Batterycapacity:
- 40Ah - 80Ah.
Outputcurrent@24V:
- 3000A peak current;
- 1000A starter current.
Outputcurrent@12V:
- 6000A peak current;
- 2000A starter current.
Coppercables:
- PVC insulated 25mm
2.
Cablelength:
- 220cm.
Outputsocket:
- 12V DC / max. current 10A.
Generalfeatures:
- re-settable safety switch for output overload;
- automatic charging level reset switch;
- “cigar-lighter” type socket, 12V DC.
Weight:
- 39kg.
Standardaccessories:
-
T-CHARGE 12 Power supply / Battery charger (Fig. B).
… 4 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Telwin START PLUS 6824 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info