ENGLISH
| 39
Refer to page 46 to raise or drop the feed dog.
After you finish sewing, set the drop feed lever
to the original position.
Sewing buttons
A pin can be placed on top of the foot to form a shank.
Set the pattern selector at B . Align the both holes of the button with the slot of the
foot and place the left hole of the button just below the needle point. Lower the foot
and turn the pattern selector until the needle point comes just above the right hole of
the button. Sew about five stitches and raise needle. Set the pattern selector at B
again and sew a few stitches to lock thread.
To strengthen the shank, cut the
threads leaving a 20 cm tail.
Bring the needle thread down through
the hole in the button and wind it
around the shank.
Draw the thread to the wrong side
and knot.
Drop the feed dog.
You do not have to
adjust the stitch length
dial.
