Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with a dry cloth.
Do not block any ventilation openings.
Install in accordance with the manufacturer’s instructions.
Do not install or operate near any heat sources such as radiators,
stoves, or other apparatus that produce heat.
- This lightning ash with arrowhead symbol within
an equilateral triangle is intended to alert the
user to the presence of non-insulated “dangerous
voltage” within the product’s enclosure that may
be of sucient magnitude to constitute a risk of
electric shock.
- Warning: To reduce the risk of electric shock, do
not remove cover (or back) as there are no user-
serviceable parts inside. Refer servicing to qualied
personnel.
- The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and maintenance
instructions in the literature accompanying the
appliance.
CAUTION!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
Unplug this apparatus during lightning storms or when unused for
long periods of time.
Refer all servicing to qualied service personnel. Servicing is
required when the apparatus has been damaged in any way, such
as the power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate normally, or has
been dropped.
Warning: To reduce the risk of re or electrical shock, do not expose
this product to rain or moisture. The product must not be exposed
to dripping and splashing and no object lled with liquids such as a
vase of owers should be placed on the product.
No naked ame sources such as candles should be placed on the
product.
Caution: Changes or modications not expressly approved by the
manufacturer could void the user’s authority to operate this device.
Caution: Usage of controls or adjustments or performance of
procedures other than those specied herein may result in
hazardous exposure.
Batteries (a battery pack or installed batteries) shall not be subject
to excessive heat such as sunshine, re or the like.
IMPORTANT SAFETY INFORMATION CONTROLS & CONNECTIONS
Power cord1.
FM aerial2.
Down/Hour adjust3.
Up/Minute adjust4.
Volume down/Alarm select5.
Volume up/ Alarm 2 select6.
Alarm 2 set with buzzer indicator7.
Alarm 2 set with radio indicator8.
Time display9.
Alarm 1 set with radio indicator10.
Alarm 1 set with buzzer indicator11.
O/FM AM band selector12.
Time set/Preset store13.
Snooze/Sleep/Dimmer14.
You can t 2 x AA batteries (not supplied) to your clock
radio to retain clock and alarm settings in the event of
a power cut. If the radio loses the time setting during a
power cut, the batteries may need to be replaced.
Fitting/replacing batteries
Slide o the battery cover in the direction shown.1.
If batteries are tted, remove the batteries from 2.
the battery compartment.
Replace the batteries with the same type AA, 3.
observing polarity. Lay the batteries over the
ribbon as shown to help with removal.
Re-t the cover.4.
BATTERY DISPOSAL
Dispose of used batteries with regard to the recycling
regulations in your area. Do NOT short circuit batteries
or throw them into water, the general rubbish or in a
re.
Weak batteries can leak and damage the unit. Replace
them in good time!
FITTING BACKUP BATTERIES
a
c
IMPORTANT SAFETY INFORMATION
1. Protect the power cord from being walked on or pinched
particularly at the plugs, convenience receptacles, and at the point
where they exit from the apparatus.
2. Only use attachments/accessories specied by the manufacturer.
3. Do not install this equipment in a conned or building-in space
such as a book case or similar unit, and remain a well ventilation
conditions at open site. The ventilation should not be impeded by
covering the ventilation openings with items such as newspaper,
table-cloths, curtains etc.
4. WARNING: Please refer the information on exterior bottom
enclosure for electrical and safety information before installing or
operating the apparatus
IMPORTANT
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communication. However, this is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ELECTRICAL INFORMATION
Mains Supply: The mains operating voltage is marked on a rating
plate under the radio.
The means of disconnecting this appliance from the mains supply
is the AC mains plug. This should be unobstructed and readily
operable at all times.
5. This equipment is a Class II or double insulated
electrical appliance. It has been designed in such a
way that it does not require a safety connection to
electrical earth.
6. Use of the apparatus in moderate climates.
