776436
7
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
Vertical Steam
Select the Steam level and wait for the selector to stop ashing.
Set the iron to its highest temperature and wait for the pilot light
to go out.
Set the iron vertical. Hold the iron away from you and 15 – 30 cen-
timetres from the garment.
Press the Steam Button for a few seconds. Steam will penetrate
into the garment removing the wrinkles.
For stubborn wrinkles: Wait a few seconds. Repeat the procedure.
Most wrinkles can be removed within three presses.
Warning: DO NOT allow anyone to come near you during this pro-
cess. NEVER allow steam to get anywhere near your body or cloth-
ing or apply steam to clothes or fabrics that are being worn by
humans or pets. DANGER OF SCALDING.
Hold the iron facing away from you at all times.
DO NOT OVERREACH or operate the iron while standing on a lad-
der etc.
Make sure that the power cord and the iron cords remain slack and
that there is no danger of overturning the steam station base.
CONTROL PANEL WARNINGS AND ACTIONS
Low Water Level Indicator
If the water in the tank is too low, the low water level indica-
tor will illuminate. You will hear two beeps and the steam
generator will shut o. You must now rell the water tank
and reset the appliance.
After relling the tank, press the Reset Button once to ex-
tinguish the low water level indicator. You can now release
steam for ironing
Descaling Indicator
If the mineral deposits in the anti-calc lter have reached a
high level the descaling indicator ashes and will continue
to ash until the anti-calc lter is replaced.
1. Depress and hold the On/O button to switch the appliance o.
2. The anti-calc lter is in the base. Grasp the anti-calc lter and re-
move it from the housing following the procedure on Page 4. Dis-
pose of the used lter at a recycling centre.
3. A replacement anti-calc lter is provided. Unwrap the lter and
place it for two minutes in clean water before inserting it in the
steam station.
4. Switch the appliance on with the On/O button.
5. If the descaling indicator stays on after replacing the lter, press
the Reset button to reset the unit before resuming operations. If
the indicator still stays on, switch the unit o. Remove and re-t
the lter before switching on and resetting the unit again.
Do not operate the iron with an ineective anti-calc lter, or
without a lter. The pump action of the appliance will be im-
paired and the steam function could fail altogether.
If you live in a hard water area, using demineralised or dis-
tilled water will prolong the life of the anti-calc lter.
Page 7
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Tesco IRSG2416 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info