Bedienungsanleitung Tesla Model 3 - 2018 (Seite 115 von 165) (Englisch)

719238

115

Zoom out

Zoom in

Vorherige Seite

1/165

Nächste Seite

Maintaining Tire Pressures

Keep tires inﬂated to the pressures shown on

the Tire and Loading Information label, even if

it diers from the pressure printed on the tire

itself. The Tire and Loading Information label is

located on the center door pillar and is visible

when the driver’s door is open.

Note: If your Model 3 is

ﬁtted with Tesla

accessory wheels or tires, some information

may be

dierent from the labels on the

vehicle. See Accessory Wheels and Tires on

page 127.

The Tire Pressure indicator light on

the touchscreen alerts you if one or

more tires is under- or over-inﬂated.

The Tire Pressure indicator light does not

immediately turn o when you adjust tire

pressure. After inﬂating the tire to the

recommended pressure, you must drive over

15 mph (25 km/h) for more than 10 minutes to

activate the Tire Pressure Monitoring System

(TPMS), which turns

o the Tire Pressure

indicator light.

If the indicator light ﬂashes for one minute

whenever you power on Model 3, a fault with

the TPMS is detected (see TPMS Malfunction

on page 118).

Note: Display tire pressures in the "Cards"

area, located toward the bottom on the left

side of the touchscreen, as described in

Touchscreen Overview on page 4. You can

also choose whether you want to display tire

pressures using BAR or PSI by touching

Controls > Display > Settings > Tire Pressure.

Checking and Adjusting Tire Pressures

Follow these steps when tires are cold and

Model 3 has been stationary for over three

hours:

1. Remove the valve cap.

2. Firmly press an accurate tire pressure

gauge onto the valve to measure pressure.

3. If required, add or remove air to reach the

recommended pressure.

Note: You can release air by pressing the

metal stem in the center of the valve.

4. Re-check pressure using the tire gauge.

5. Repeat steps 3 and 4 as necessary until

the tire pressure is correct.

6. Replace the valve cap to prevent dirt from

entering. Periodically check the valve for

damage and leaks.

Warning: Under-inﬂation is the most

common cause of tire failures and can

cause a tire to overheat, resulting in

severe tire cracking, tread separation, or

blowout, which causes unexpected loss of

vehicle control and increased risk of

injury. Under-inﬂation also reduces the

vehicle's range and tire tread life.

Warning: Check tire pressures using an

accurate pressure gauge when tires are

cold. It takes only about one mile (1.6 km)

of driving to warm up the tires suciently

to aect tire pressures. Parking the

vehicle in direct sunlight or in hot weather

can also aect tire pressures. If you must

check warm tires, expect increased

pressures. Do not let air out of warm tires

in an attempt to match recommended

cold tire pressures. A hot tire at or below

the recommended cold tire

inﬂation

pressure is dangerously under-inﬂated.

Warning: Do not use any tire sealant

other than the type provided in a Tesla

tire repair kit. Other types can cause tire

pressure sensors to malfunction. If your

Model 3 did not include a tire repair kit,

you can purchase one from Tesla.

Tire Care and Maintenance

Maintenance 113

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tesla Model 3 - 2018 Seite 115

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info