Bedienungsanleitung Teufel Cinepaq 5100 (Seite 9 von 28) (Englisch)

704023

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

• CP 5100 DR 9

FM antenna

Connect the antenna for receiving FM/VHF stations to

the jack 13 “FM”. This can be a roof/outdoor antenna or

a cable television connection. You will need a coaxial

cable for this.

If an antenna connection is not available at your setup

location, you can use the enclosed dipole FM antenna

햶. Unwind the throw-out aerial, screw the lugs onto

the adapter

햷, push the

adapter into the jack 13

“FM” and adjust the position

of the throw-out aerial until

you have the best reception.

Then ﬁ x the antenna in place

with tape or a nail.

Setup and Connecting

Setup location

Select a stable, level base.•

Make sure that the environment is clean and free from •

dust.

Avoid placing the unit close to sources of heat or in •

direct sunlight.

Arrange the connector cables so that they do not pose •

a trip hazard.

Do not place any heavy objects on top of the cables or •

the unit.

There should be approximately 10 cm of space around •

the device to enable adequate air circulation.

Connecting the speakers

To connect the speakers, use high-quality, two-conductor

speaker cable with a diameter of at least 1.5 mm

(AWG

15). You can order cables and banana plugs in our web-

shop (www.teufelaudio.com) in the “Accessories” area.

the small cap that covers top entry of terminals 22 and

then push the plug into the visible jack of the connector

terminal.

If you don’t use any banana plugs,

turn the connector terminal 22

counterclockwise to loosen it. Insert

the stripped cable end into the hole

that is now visible. Turn the terminal

clockwise. This will clamp the cable

in place.

Subwoofer

You can connect an active subwoofer to the RCA jack

25 “Sub Out”. Only low frequency audio signals will be

issued at this jack up to an adjustable frequency.

Antennas

Danger

Risk associated with lightning strike!

If you are using outdoor or roof antennas, be

absolutely sure that the antenna has lightning

protection.

The connector terminals 22 “Speakers” for the ﬁ ve satel-

lites are located on the back of the DVD receiver:

Front – front speakers, “Left”and “Right”.•

Center – middle speakers.•

Rear – rear speakers, “Left” and “Right”.•

The terminals are each marked red (+) and black (-).

Observe the correct polarity!

Connect the like coloured terminals with each

other. Otherwise the sound quality will suffer.

The wires of the speaker cables are marked with differ-

ent colours or shapes.

Split the speaker cable on both

ends over a length of about 30 mm

and remove approximately 10 mm

of the insulation sheathing. Twist

the cable to ensure that no wires

protrude.

Connecting the cables to the speakers should be de-

scribed in the operating instructions for the speakers.

If you use banana plugs, screw the cord into place on

the plug (see instructions for the banana plug), remove

2225

햶

햷

91341 GB 20100924.indd 991341 GB 20100924.indd 9 24.09.2010 9:58:00 Uhr24.09.2010 9:58:00 Uhr

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Teufel Cinepaq 5100 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info