Bedienungsanleitung Teufel Concept S SW-R (Seite 13 von 24) (Englisch)

562428

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

· Concept S SW + R Dolby Digital/dts

Power

Switches the subwoofer on (press once) or off

(press again), after the power supply has been

switched on at the rear of the device (“Power” –

see page 11).

Mute

Pressing the button once immediately mutes the

complete system; if you press it again, the system

returns to its previous operating status. If the

system has been switched to mute, the “MUTE

ON” message on the display lights up; upon reac-

tivation “MUTE OFF” lights up briey before the

input source appears again, e.g. “OPT”.

Choice of input

Select the ve inputs plus the integrated radio

receiver here. ĕ Page 20

Station buttons

Nine buttons allow direct selection of the radio

stations saved by the user

ĕ Page 21

Station buttons switch

Allows programming of additional radio presets.

Press once for positions 11–19, twice for 20–29, 3

x 30. ĕ Page 21

stereo/Mono switch

When receiving weaker VHF/FM stations via room

aerials, the playback quality may improve notice-

ably if you switch to mono.

Mem

Memory button to assign the station buttons (4).

ĕ Page 21

Scan

For radio operation you can scan through the

frequency bands manually to get to the next

station – in ascending [+] or descending [-] order.

ĕ Page 21

Channel

In “Tuner” mode you can switch directly from sta-

tion to station – in ascending [+] or descending [-]

order

ĕ Page 21

C.Delay

Option to set the delay on the centre speaker.

Only works with Dolby Digital/dts. ĕ Page 19

{

Test

Initialises the test sound to equalise the speakers.

ĕ Page 18

}

Night Mode

Activates reduced-volume playback for Dolby Dig-

ital signals with sound adjustment at low volume

levels. Press again to deactivate Night Mode. ĕ

Page 20

Listen Mode

Used to select the various playback modes, such as

Dolby Prologic II or stereo. If a Dolby Digital signal

is active, stereo mode is forced by pressing this

button. ĕ Page 20

Reset

Call up the subwoofer’s factory settings using

this button.

S.Delay

Allows adjustment of the rear speaker time delay.

Only works with Dolby Digital/dts and Dolby Pro-

Logic II.ĕ Page 19

Centre/Woofer

Use the [+] and [-] buttons to adjust the required

levels of the centre and subwoofer.

Bass

Use the [+] and [-] buttons to adjust the required

bass level. It acts directly on both front speakers.

Treble

Use the [+] and [-] buttons to adjust the required

treble level. This sound adjustment acts directly

on both front speakers.

Volume +

This increases the overall volume.

Volume -

This reduces the overall volume.

Balance »L« »R«

The “L” and “R” buttons increase the respective

amounts of equalisation of the left (“L”) or right

(“R”) front speakers. Pressing the “Balance” but-

ton will return the equalisation to the original

balanced state.

Rear

Use the [+] and [-] buttons to regulate the re-

quired levels of the left and right rear speakers.

Tip:

The settings you make are

saved directly by the subwoofer

without any need for further

action. They will still be available

even after disconnection from

the electricity supply.

Operating elements: Remote control

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Teufel Concept S SW-R Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info