Bedienungsanleitung Teufel KB 20 CR (Seite 9 von 20) (Englisch)

703885

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

• KB 20 CR 9

Setup and connection

Location tips

• Select a stable, level base.

• Make sure that the environment is clean and free from

dust.

• Avoid placing the unit close to sources of heat or in

direct sunlight.

• Arrange the connector cables so that they do not pose

a trip hazard.

• Do not place any heavy objects on top of the cables or

the unit.

Connecting the speakers

Use the enclosed speaker cables to connect the speakers.

You can order longer cables if you need them in our web-

shop (www.teufelaudio.com) in the “Accessories” area.

The connector terminals 16 “SPEAKER” for the right (“R”)

and left (“L”) speaker are located on the back side of the

CD receiver.

The terminals are each marked in red (+) and black (-).

Make sure the polarity is correct!

Connect the like-coloured terminal clips with

one another. Otherwise, the sound quality will

suffer. The strands of the speaker cables are marked

with different colours or shapes.

• Split the single-wire down to

approx. 30 mm on both ends

and strip approx. 10 mm of

insulation off of each cord.

Twist the single wire so that

no strands are protruding. Tin

coating is not necessary.

• Flip up the connector terminal lever

up or down to open the terminal.

• Insert the stripped cable end into the

terminal opening and then fold the

lever down again. The cable has now

been clamped in place.

Antenna

Danger

Risk associated with lightning strike!

If you are using outdoor or roof antennas, be

absolutely sure that the antenna has lightning

protection.

Connect the antenna for receiving FM/USW stations to

the jack 17 “FM”. This may be a roof/outside antenna,

but also a cable television connection. You will need a

coaxial connector cable for this.

If no antenna connection is available at the location, you

can use the enclosed throw-out aerial

햵. Push the aerial plug into the jack

17 “FM” and adjust the position of

the throw-out aerial for best recep-

tion. Then ﬁ x the antenna in place

with adhesive tape.

Audio input

You can connect almost any audio source such as a com-

puter, MP3 player (with/without a dock), video game sys-

tem, television etc. to the RCA jacks 18 “AUX IN” on the

back side of the device. The source device only requires

an output with line control. Such outputs are conﬁ gured

either as stereo RCA jacks or as 3.5 mm jack plug. You

can connect these devices to the jacks 18 “AUX IN” with

a corresponding connector cable. You can ﬁ nd such

cables in our webshop (www.teufelaudio.com) in the “Ac-

cessories” area.

Connecting to a power supply

Connect the jack 19 on the back side of the device with a

power supply socket via the power cord

햴. The standby

light 1 on the front of the device will illuminate in blue.

16 17 18 19

–

91886 GB 20111117.indd 991886 GB 20111117.indd 9 17.11.11 15:4317.11.11 15:43

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Teufel KB 20 CR Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info