Bedienungsanleitung Teufel US 5305 (Seite 5 von 8) (Englisch)

703873

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Setup and connection

Setup notes

• Select a stable, level base.

• Make sure that the environment is clean and free from dust.

• Avoid placing the unit close to sources of heat or in direct

sunlight.

• Arrange the connector cables so that they do not pose a trip

hazard.

• Do not place any heavy objects on the cables or the speak-

ers.

• The location of the subwoofer can be freely selected and

does not inﬂ uence the other speakers. However, do not place

it in the corner of a room as this may cause uncontrollable

frequency overloads. A location between the front speakers

is often ideal.

Connecting

Danger

Danger of injury/damage!

Arrange the cables so that they do not pose a

trip hazard.

Subwoofer

1. Pull the power plugs of all devices to be connected out of the

socket so that inadvertent switch-on is excluded.

Pre Out

Front

Left

Right

CenterRear Front CenterRear

Front SubRear Front SubRear Coaxial 2 Optical 1

5.1 In

Aux CD TV Coaxial 1

Stereo In Digital In

DecoderStation

Subwoofer

US 5305/6

Analogue

5.1 source

e.g. sound card

Analogue

sources

Digital

sources

2. Connect the LINE IN jacks 1 of the subwoofer with the 5.1

output jacks of a preampliﬁ er such as a decoder station using

the included RCA cable.

Satellite speakers

Make sure the polarity is correct!

Connect the like coloured terminals. Otherwise the

sound quality will suffer.

The strands of the speaker cables are marked with different

colours or shapes.

• The terminal 6 for connecting the satellite speakers is lo-

cated on the back side of the subwoofer.

• Here you can connect the speaker cables directly or with

pin plugs. We only describe the direct connection in these

instructions.

1. Lay the included speaker cables from your subwoofer to

each of the speakers.

Little hint: Label the cables on the subwoofer side – this will

help when taking down and setting up your audio equipment.

2. Split the single wire down to approx. 30 mm on both ends

and strip approx. 10 mm of insulation off of each cord.

3. Twist the stripped single wire ends together so that no wire

protrudes. Tin coating is not necessary.

4. Turn the connector terminal counterclockwise until loose.

Run the stripped cable end into the now visible hole. Close

the terminal by turning it counterclockwise. The cable has

now been clamped in place.

5. Connect the other cable ends to your satellite speakers. The

operating instructions of the speakers should contain notes

on this.

Connection to the grid

1. Ensure that the mains switch 7 “Power” on the subwoofer is

switched off (“OFF” position).

2. Connect the mains connector jack 8 with a mains socket us-

ing the power cord 햳.

3. Also plug the mains plug of your AV receiver back into the

socket.

4. Turn the mains switch 7 “Power” on the subwoofer to “ON”.

92094 GB 20120301.indd 592094 GB 20120301.indd 5 01.03.12 16:1801.03.12 16:18

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Teufel US 5305 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info