Bedienungsanleitung Texas Razor 5130 TR-W (Seite 15 von 62) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Polnisch)

636635

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

Mulching plug: Illustration M7-2

1. Insert the mulching plug and remove side

discharge guard, if you want to mow with mulching

functionality.

NB Don’t use the grass collector

Important: Remember to remove the mulching plug,

when using the grass collector.

Side discharge guard: Illustration M7-3*

1. Lift the side guard and insert side discharge guard.

Then insert the mulching plug in rear discharger to

mow with side discharge function. NB Don’t use the

grass collector

* Note: Not all models do have side discharge guard

Cable Adjustment

The following cables may be necessary to readjust:

Illustration A1

1. Cable for drive

2. Cable for engine brake

3. Cable for throttle cable

Note: The choke cable cannot be adjusted!

Adjusting the drive cable: Illustration A1-1

If you experience slack in the drive cable, this can be

solved simply by tighten or loosen the bolt on the cable.

1. Tighten turning clockwise - loosen the cable.

2. Tighten turning anti clockwise - tighten the cable.

Adjusting the engine brake cable: Illustration A1-2

If you experience slack in engine brake cable, this can

be solved simply by tighten or loosen the bolt on the

engine block.

Adjusting the throttle cable: Illustration A1-3

If you experience slack in revolution cable, this can be

solved simply by tighten or loosen the bolt on the

engine block.

Battery (Electric starter)*

Charge the battery before use

Before the electric start function is used, the battery

must be charged for 5 hours. Put the charger plug into

the hole in the battery and connect the charger to a

power supply. See illustration. A4

Charging during the season

The battery is charged a little during use, buy it will

likely be necessary to charge the battery a couple of

times during the season - depending if the number of

start/stops of the engine. Put it for charging for around 5

hours.

Storage of battery

The battery must always be stored dry and warm during

the winter. Never expose it for low temperatures.

Charge the battery completely before storing and then

place the lawn mower in a place where it is not exposed

to frost. Alternatively cover the battery with a thick

carpet or similar, If the mower is in a shed/garage

where there may be cold.

Charge the battery 1-2 times during the winter (at least

every 3

month) to make sure the battery keeps it full

capacity.

Incorrect storage can damage the battery, and is not

covered by warranty.

* Note: Not all models have electric starter

Operation

Always check and refill oil before the start!

Read and apply the instructions given in the

enclosed start guide!

The oil level should always be between min. and max

on the dipstick. Fill with SAE-30 oil. There should be

total 0.6 liter oil in the engine. Use only unleaded 95

octane fuel to the engine. Never overfill the tank.

Cutting height adjustment: Illustration F1

(the illustrations may vary from your actual model)

The mower has 6 different heights. The cutting height

ranges from 28 mm to 75 mm

Start: Never start the mower directly on long grass.

Recoil with primer, illustration F2

1. Push the primer several times, first time push 1-3

times, if necessary supplement with up to 3-5

times.

Note: It is not possible to drown engine

2. Hold the handlebar for the engine brake; this will

release the engine brake.

3. Pull the recoil starter gently until you feel resistance

in the rope, then pull quickly and energetic. Do not

at any time let go of the recoil starter but slide it

gently into starting position.

4. Hold the bar for self-propelled in order to start

mowing

Recoil with choke, throttle lever illustration F3-A

1. By cold engine set the choke lever on ”Choke”- By

warm engine set the choke lever on ”Run”

2. Move the throttle lever to full “Rabbit”(A)

3. Hold the handlebar for the engine brake; this will

release the engine brake.

4. Pull the recoil starter gently until you feel resistance

in the rope, then pull quickly and energetic. Do not

at any time let go of the recoil starter but slide it

gently into starting position.

5. Adjust the throttle lever if necessary and return the

choke lever in the ”run” position. (only cold engine)

6. Hold the bar for self-propelled in order to start

mowing.

Electrical starter, illustration F3-B

1. By cold engine set the choke lever on ”Choke”- By

warm engine set the choke lever on ”Run”

2. Move the throttle lever to full “Rabbit” (A)

3. Hold the handlebar for the engine brake; this will

release the engine brake.

4. Push the Electrical start button (B)

5. Adjust the throttle lever if necessary and return the

choke lever in the ”run” position. (only cold engine)

6. Hold the bar for self-propelled in order to start

mowing.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Texas Razor 5130 TR-W Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info