18
SETTING UP:
When one transmitter is used
1. First, insert the batteries into the Temperature Transmitter. (see “To install
and replace batteries in the Temperature Transmitter“).
2. Immediately after and within 2 minutes, insert the batteries into Temperature
station. Once the batteries are in place, all segments of the LCD will light up
briefly. Following the time as 0:00 and the indoor temperature will be
displayed. If these are not displayed after 60 seconds, remove the batteries
and wait for at least 10 seconds before reinserting them.
3. After inserting the batteries into the transmitter, the Temperature Station will
start receiving data from the transmitter. The outdoor temperature and the
signal reception icon should then be displayed on the Temperature station. If
this does not happen after 3 minutes, the batteries will need to be removed
from both units and reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, this should under
good conditions be a distance no more than 100 meters between the final
