3130
Meteotime Fiesta - Weather Info Center
╞
• If you want to connect additional transmitters, select the CHANNEL slide in
the battery compartment of the transmitter, for each outdoor transmitter
another channel (2 or 3).
• Insert two new batteries 1,5 V AA in the battery compartment of the out-
door transmitter. Ensure batteries polarities are correct.
• Select with the [CHANNEL] button on the basic station the free channel.
• Press and hold the [
▼
] button on the basic station for three seconds and
start the initialization.
• The reception symbol will be flashing above the channel number.
• As soon as the outdoor values are received, the reception symbol remains
and the received outdoor values appear on the display.
8.2
Reception symbols
• The wave icon above the current channel icon shows the connection status
of the corresponding transmitter:
Searching for the signals from the transmitter
Corresponding transmitter signal received successfully
No signals received for over 1 hour
8.3
Search for outdoor transmitter
• The weather station can be activated manually by press-
ing and holding the [
▼
] button to locate signals from an
outdoor transmitter.
8.4
Indication of the outdoor temperature (channel)
Static display:
• Press the [CHANNEL] button to select the measurements from the different
outdoor transmitters on channel 1,2, or 3.
Channel Auto-Scan display:
• To enable an automatic scan of all channels, press and hold the [CHANNEL]
button, until the icon is displayed. The measurements from each remote
channel will be displayed in 5 seconds alternatively.
• NOTE
:
the channel auto-scan feature can be active only if there are more than one
outdoor transmitters operating and are set to different channels.
Meteotime Fiesta - Weather Info Center
╞
9. Maximum and minimum temperatures
•
The maximum and minimum recorded indoor and outdoor temperatures will
be automatically stored in the memory of the main unit. Press the
[MEM]
but-
ton, the respective indicators, or will then be displayed.
•
To clear the memory, hold the
[MEM]
button for 3 seconds. The maximum and
minimum temperature records will be erased.
10. Alarm functions
•
There are three different alarm functions:
Weekday alarm (W-ALM)
:
This is a repeat alarm that will be activated daily from Monday to Friday at a
set time.
Single alarm (S-ALM)
:
This is a single alarm that will be activated once at a set time.
Pre-alarm (P-ALM):
Earlier wake-up time in case of frost.
10.1
How to set the alarms
• Press the [SET] button to toggle between weekday alarm (W-ALM), single
alarm (S-ALM) or pre-alarm (P-ALM).
•
OFF
appears in the display of each alarm when the alarm is turned off.
10.1.1
Weekday alarm (W-ALM) and single alarm (S-ALM):
• Press the [SET] button to set the weekday alarm (W-ALM) or the single alarm
(S-ALM).
• Press and hold the [SET] button for 3 seconds, the hour digits will be flash-
ing.
• Enter the hour by using [
▲
] or [
▼
] button.
• Press the [SET] button to confirm, the minute digits will be flashing.
• Enter the minutes by using [
▲
] or [
▼
] button.
• Press the [SET] button to exit and the respective alarm symbols [ ] or [ ]
will be activated.
10.1.2 Setting the ice warning
PRE-ALARM
(outdoor temperature at transmitter 1 =/< 0°C)
• If the weekday (W-ALM) or the single day (S-ALM) alarm is set and an out-
door transmitter is installed on channel 1, the ice warning alarm (P-ALM) can
be programmed.
TFA_No. 35.1130_Anleitung 04.04.2014 11:05 Uhr Seite 16