2120
Radio-controlled alarm clock
Radio-controlled alarm clock
• To activate or deactivate the alarm function press the corresponding
button. The corresponding symbol appears or disappears. , ,
+ or no symbol appears on the display.
• Press any alarm button to stop the alarm.
• The snooze function can be activated with the IR motion sensor
(wave hand 5 cm above the sensor).
• Zz flashes on the display.
• For the duration of the pre-set interval function, the alarm will be
interrupted up to four times.
• If the alarm sound will not be interrupted manually, the alarm clock
will ring four minutes.
• Press mode button in normal mode to change the display between
alarm time 1 or 2.
6.6 Backlight
• With the IR motion sensor (wave hand 5 cm above the sensor) the
backlight will be activated for 5 seconds.
7. Battery replacement
• Replace the batteries when battery symbol appears.
8. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or
scouring agents.
• Confirm with the mode button.
• Press and hold the ▲ button.
• F disappears and the display shows the current time.
6.4 12 and 24 hours system indication
• Press the ▲ button in normal mode to choose 12 HR or 24 HR sys-
tem.
• In 12 HR system AM or PM appears on the display.
6.5 Setting of the alarm time
• Press and hold the AL 1 button.
• The hour digits are flashing (AL 1).
• Press the ▲ or ▼ button to adjust hours.
• Press the AL 1 button again.
• The minute digits are flashing. Press the ▲ or ▼ button to adjust the
minutes.
• Press the AL 1 button again.
• The indication of the snooze interval (04 default) is flashing and you
can adjust the snooze interval (from 1 minute to 59 minutes) with
the ▲ or ▼ button.
• Confirm with the AL 1 button.
• Press and hold the AL 2 button to adjust the second alarm time.
• AL2 appears on the display and the hour digits are flashing.
• If necessary adjust the second alarm time in the same way.
TFA_No. 60.2534_Anleitung 04.02.2016 09:51 Uhr Seite 11
