Page.4
2. Operating instructions
The remote control and its operation. (See Page 14 diagram 6)
Control buttons and other functions of the gas regulator block GV34 (A), the receiver G30-ZRRTT
(F) and hand transmitter remote control G30-ZRHTT (B)
Ensure that the batteries have been correctly placed in the remote control and battery holder/signal receiver
(see Page 14-B1 and F2).
· Ignition knob pilot light (A1)
· Manual control gas fire (A2)
· Remote control (B)
· Remote control DISPLAY (B-3)
· Remote control AUTO FUNCTION (B-4)
· Remote control TIMER FUNCTION (B-5)
· Remote control flame height HIGHER (B-6)
· Remote control flame height LOWER (B-7)
Adjusting the temperature display (ºC en ºF)
After the 9 V battery (B-1) has been connected, the auto and timer buttons can be pressed simultaneously
to change the temperature setting. The display will start flashing and the adjustment mode has now been ac-
tivated. Change temperature from ºF to ºC by pressing the auto button. This function can also be used to set
the clock at the correct time, by pressing the high/low buttons high: hours, low: minutes.
The display will automatically return to the Start position, but this can also be done by pushing the timer
button.
Setting the required temperature
Press the auto button until the display starts to flash. Use the high/low buttons to set the required tempera-
ture. Wait or now press the auto button again and the display will return to the auto
position. A temperature
sensor in the remote control measures the ambient temperature. The remote control compares the ambient
temperature with the temperature set and subsequently sends a signal to the receiver, which operates the gas
block motor to increase or reduce the flame height
Setting the timer function
Press the timer button until display P 1
* flashes. Now use the high/low buttons : hours/minutes to set the
time for the first heating period.
Press the timer button until display P 1
) appears. Now use the high/low buttons : hours/minutes to set the
time for the end of the first period.
Press the timer button until display P 2 * flashes. Now use the high/low buttons : hours/minutes to set the
time for the first heating period.
Press the timer button until display P 2 ) appears. Now use the high/low buttons : hours/minutes to set the
time for the end of the first heating period.
Either wait or press the timer button, and the display will return to the timer setting. If the symbol ) ap-
pears, the present time is outside the heating period.
