Bedienungsanleitung Thermocet LIGERO (Seite 12 von 27) (Englisch, Holländisch, Norwegisch)

607257

Zoom out

Zoom in

Vorherige Seite

1/27

Nächste Seite

Pag.3

1. Mantelpiece “LIGERO”

The mantelpiece LIGERO is a design that can be applied in many interiors because of its many possibilities.

Thanks to the partly deliveries you can compose the mantelpiece according to your wishes. All partly deliver-

ies are separately packed in a box. At delivery you should immediately check the mantelpiece and the partly

deliveries you have selected for any (transport) damage. If this is found, you should inform your supplier on

this as accurately as possible right away. See for this the delivery document. Before placing the mantelpiece

LIGERO and the HI-FIRE basic unit, we advise you to carefully read the accompanying MOUNTING

INSTRUCTIONS AND OPERATING AND INSTALLATION INSTRUCTIONS in order to avoid problems

during mounting.

Guarantee

See HI-FIRE basic unit

2. Place the basic mantelpiece “LIGERO” (see page 5 fig. 1)

Attention

Before placing the HI-FIRE basic unit (1), first the mantelpiece is to be put on the place you have carefully

chosen. Because the mantelpiece is rather sturdy and heavy, we advise you to lay the box with the contents on

the back. First remove the carton accessories from the box. Now the mantelpiece (2 and 3) can carefully be

taken out of the box. Dismount the door (3) by lifting it from its hinges. Check the mantelpiece for any dam-

age.

Preparation

It is of major importance that you do not place the mantelpiece (2) too high, otherwise you will look at the

bottom of the appliance. We advise you not to exceed a maximum height of 350 mm measured from the floor

to the bottom side of the mantelpiece (see page 8 figs. 4 and 5). At the rear side of the mantelpiece there

are four fixing holes for hanging the mantelpiece on the wall. Drill the hole pattern as indicated on page 5

fig. 1. Put the table bolts into the wall. Now you can fasten the HI-FIRE basic unit (1) to the mantelpiece.

Unscrew the six bolts delivered with the HI-FIRE basic unit (1) from the unit. Lift the mantelpiece over

the basic unit and fasten the mantelpiece with the six bolts onto the basic unit. Place and fasten the entire

appliance with the delivered M10 nuts and body rings on the wall. For connecting and installing the

HI-FIRE basic unit (1) we refer to the OPERATING AND INSTALLATION INSTRUCTIONS of this

unit. Finally place the door (3) on the hinge points intended for this again so that you can close the door.

3. Place the basic mantelpiece “LIGERO” with socle (see page 6 fig. 2)

Place socle and mantelpiece (see page 6 fig. 2)

Attention

Before placing the HI-FIRE basic unit (1) and the socle (5), first the mantelpiece is to be put on the place

you have carefully chosen. Because the mantelpiece is rather sturdy and heavy, we advise you to lay

the box with the contents on the back. First remove the carton accessories from the box. Now the mantelpiece

can carefully be taken out of the box. Dismount the door (3) by lifting it from its hinges.

Check the mantelpiece for any damage. Take the socle (5) out of the box and check this for damage.

Preparation

Housing gas-supply pipe (see page 9 fig. 6)

As the HI-FIRE is a basic unit, the gas-supply connection may need to be moved. This also applies to the

combination you have chosen.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thermocet LIGERO Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info