Bedienungsanleitung Thermocet N21- INTIMO TWO TONE (Seite 15 von 28) (Englisch)

607250

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Page 15

5. Installation instructions

General

The appliance is a completely sealed construction, which is to say that it can be used in chink-free, me-

chanically ventilated homes, without additional ventilation being required. The special concentric duct

system enables the natural discharge of flue gas and supply of combustion air from and to the appli-

ance. Various forms of outlet and routing are possible with this venting system, so that the positioning

of the appliance is flexible.

Attention

* The appliance should be installed, connected and inspected by a registered installer in accor-

dance with national and regional norms.

* The appliance should be inspected by the installer for gas tightness to gas products and combus-

tion products and for correct operation of the various components and functions.

* The venting system and the outlets in the exterior wall or roof surface must comply with the regu-

lations currently in force.

* The appliance is classified as a sealed appliance installed in a location without ventilator and with

a chimney loss in excess of 17% (non-condensing).

* To maximise the heat output of your fire when it is built-in a wall or surround, you can use the op-

tional convection set consisting of 2 ducts, grills and brackets.

Clearance to combustibles

* From the front and sides of the stove a clearance of 500 mm should be taken to curtains, drapes

and other Fabrics

Clearance to non-combustibles

* Construction materials for surround and mantels must be made of non-combustible material.

Attention: this include floor and ceiling

* When installing the appliance, you must maintain a minimum clearance of 20 mm from the wall at

all times.

Maintenance

* The appliance can be cleaned with a soft damp cloth. The appliance should be turned off immedi-

ately if something is spilled on it. The marks can be removed with mild soapy water once the ap-

pliance has cooled down. NEVER use an abrasive!!!

* Any deposit on the glass can be removed with glass cleaner.

* It is advisable to have the fire and the chimney checked and cleaned by an installer before every

heating season. If the special glass is broken or cracked, have it replaced immediately before you

turn the stove on again. In the heating season it is advisable to leave the pilot light on against

condensation in the appliance. If the stove will not be used for a longer period it would be wise to

shut off the gas gas-valve in the supply pipe.

Connection to the gas pipe

Ensure that the control equipment does not become twisted during connection and that no excessive

tension develops. Check the connections for gas tightness after installation. Connect the supply pipe at

the gas-valve with a 3/8” coupling and make sure that the gas pipe is free of dirt and sand.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thermocet N21- INTIMO TWO TONE Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info