Bedienungsanleitung Thermocet Trimline 100 -1036 (Seite 23 von 41) (Englisch)

607237

Zoom out

Zoom in

Vorherige Seite

1/41

Nächste Seite

Page.23

11. PLACING THE UNIT (first read “General instructions”)

Please note: Before placing the unit, we recommend you first read Chapter 7 “Concentric flue system” on

page 11.

11.1 Unit components (see page 34, figures 6 and 7.)

1 Unit 5 Window 9 Set screw 13 Baffle plate

2 Stainless steel front 6 Burner plate 10 Adjustment leg 14 Restriction plate

3 Glass strip 7 Burner 11 Wall brackets

4 Glass strip fixing bolts 8 Bottom plate 12 Control box

11.2 Connection to the gas pipes (see also page 25 for details)

You can determine where the gas pipes will be placed, dependent on the layout. Ensure control equipment is not

twisted during installation and there is no excessive tension. Accessibility of various connection points in relation

to components need to be maintained. After installation, check the connections for tightness in relation to gas.

Use a 1/2“ gas tap with connection. Ensure the gas pipes are dirt-free and sand-free, and gas and combustion

products from various parts and functioning is correct. The gas connection should only be undertaken when the

electricity supply is dead. This prevents any damage occurring to the gas control equipment.

11.3 Preparation and installation of the unit

* Remove the packaging and check the unit for possible damage.

* Note: place the unit on a stable surface.

* Do not place the unit on its back or on its side.

* Take the lifting frame (A) out of the packaging and use it to place the unit (B) at its

intended location

* The window should now be removed in order to take the additional parts out of the

unit.

* Remove the glass strip (C) by unscrewing the 3, 4 or 5 countersunk Allen screws

(page 34 figure 6-4).

Carefully remove the glass strip from its fixture, possibly with the aid of a screw

driver.

* By placing the supplied suction cups (D) evenly over the glass window, the window

can be easily removed from the unit by first carefully moving it upwards and then

very carefully and slowly pulling the bottom of the window towards you; next, put the

window down and leave it in a safe place where it cannot be broken or damaged.

Please note: the window is very fragile.

You should therefore be very careful when moving/ installing the window!

* Next, take the packaged components out of the unit and check to make

sure they are not damaged or broken.

* Situate the unit (see page 35 figures 8 and 9as an example of an instal-

lation location) in your chosen installation location using the lifting

frame (A and B). At the rear and the sides, the unit must have at least

50 mm clearance from fireproof built-in materials. Install the convec-

tion set and position the supplied convection grilles at least 50 cm be

low the ceiling (see page 35 and 36 figures 8C and 9C) on the appropri

ate wall. A lowered ceiling inside the whole structure (fireproof built-in

materials) could be a possible solution in the event of a situation with a

visual obstruction.

Please note: Convection temperature output can be over 100 °C at

the convection grilles

Attention: in an installation location similar to figure 7, a mantle iron will have to be installed. See also the

detail on page 35figure 8A for the installation of the mantle iron.

* The legs of the unit can provide additional height of up to 300 mm (min. 185 and max. 485) for the rough

adjustment using the set screw (9). The adjustment legs (5) allow the unit to be adjusted more finely.

* Attach the unit to the wall using the wall brackets (11) for a stable installation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thermocet Trimline 100 -1036 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info