Bedienungsanleitung Thermocet Trimline 120 -1037 (Seite 24 von 41) (Englisch)

607238

Zoom out

Zoom in

Vorherige Seite

1/41

Nächste Seite

Page.24

* Now determine the installation and assembly of the CC ducts and accessories. Please refer to Chapter 7

“Concentric flue system” on page 11 and the “Table of concentric pathways” on page 28.

* Install the Mertik control Box (12) in your chosen installation location.

Please note:

The distance between the control cabinet and the unit will be determined by the cable lengths from

the control cabinet to the pilot burner and the gas block etc. and how all these items are installed.

The max. distance is 800 mm (see also page 32 and 33 figures 1 to 5). The pipes, cables and/or cou-

plings etc. should only be connected when the electricity supply is off.

* It is also possible to install the fireplace using fireproof sheets

* The slats, log inset / pebbles or Carrara stones may now be installed.

MAKE SURE THE PILOT LIGHT REMAINS UNOBSTRUCTED!

* Before reinserting the window, check whether or not a restriction plate needs to be installed.

See page 20 and the “Table of concentric pathways” on page 28.

* If a restriction plate is required for your installation situation, remove the baffle plate (13) by un screw-

ing the front of the plate (see page 34 figure 7) and then sliding the plate backwards and taking it out.

Now install the restriction plate (14) using the two supplied screws and reinsert the baffle plate.

11.4 Fitting the ceramic log inset 1035, 1036, 1037, 1038 and 1039 (see pages 37, 38 and 39)

Please note: when installing the log inset and the various glowing materials and accessories, the fol-

lowing must be taken into account:

A: There should be no glowing material in or on the pilot burner.

B: Ceramic materials should not come into contact with the cord of the window fixture.

Remove this if necessary. The window may otherwise be damaged.

* Mix the glowing material (lava granules) and the “fusilli” (spiral-shaped ceramic material) and spread

them evenly over the burner and the burner plate so that they are just covered. Glowing embers can be

placed here and there as decoration.

NOTE: the remaining material can be discarded. The use of too much glowing material can adversely af-

fect the combustion process (see also notes A and B above)

* Then insert the logs in the correct order as shown on pages 37, 38 and 39.

* Position the log inset carefully. Different positions may have a significant influence on the flame image or

cause poor functioning of the burning process (explosion).

11.5 Fitting the optional pebble set (see page 40 figure 10)

* Scatter vermiculite evenly over the burner tray. Make sure the pilot light remains unobstructed.

* Place a row of medium-sized and large pebbles at the front of the burner plate

* Insert the pilot light protective cage in the 2 sockets to the left and right of the pilot light.

* Fill the burner tray with small and medium-sized pebbles from the front to the rear. Place the pebbles as

closely as possible to each other on the burner tray.

* Fill the rear of the burner plate with medium-sized and large pebbles.

* Reinstall the window, following the instructions for removing it in reverse order.

11.6 Fitting the optional Carrara stones (see page 40 figure 11)

* Scatter vermiculite evenly over the burner tray. Make sure the pilot light remains unobstructed.

* Insert the pilot light protective cage in the 2 sockets to the left and right of the pilot light.

* Fill the burner tray neatly and evenly with the Carrara stones.

* Reinstall the window, following the instructions for removing it in reverse order.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thermocet Trimline 120 -1037 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info