Bedienungsanleitung Thermocet Trimline Quadro 46 (Seite 4 von 85) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Spanisch)

532670

Zoom out

Zoom in

Vorherige Seite

1/85

Nächste Seite

Page.4

The unit has a layer of heat-resistant varnish that resists very high temperatures.

An unpleasant smell may develop in the first hours after starting the unit due to burning

in of the varnish; however, this is not dangerous. To accelerate this process, allow the

unit to burn at the highest setting for several hours and ventilate the area well.

After the first time the unit is turned on, a light deposit may form on the inside of the window.

This is due to the varnish hardening. After the fireplace has cooled down, this deposit can

be removed using a fireplace glass cleaner or ceramic hotplate cleaner.

4.1 Maintenance and cleaning

Daily maintenance

Avoid having a lot of dust and cigarette smoke, candle and oil lamp particles in the air

of your home. Heating of these particles through the convection system of the unit, can lead

to discolouring of walls and ceilings. It is therefore advisable to ensure the area containing

the unit is always sufficiently ventilated.

Regularly remove any dust that has settled behind the operating lid with a vacuum cleaner.

The unit must be switched off immediately if something is spilt on it. It should only be cleaned

once the unit has cooled down. Never use abrasive, aggressive cleaning products or fireplace

cleaner; only use a dry cloth that does not give off fluff.

Cleaning.

The unit should be cleaned and checked every year by your dealer.

The Concentric flue system must be cleaned every 2 years.

From dealers aerosols available heat-resistant paint? Bier, so that the annual

maintenance small stains or damages may be touched.

Also Verification:

1 Density of the gas combustion products and combustion air feed circuit.

2 The correct operation of the gas control block and the ignition of the burner.

If the glass is broken or cracked, it should be replaced immediately by a recognised fitter

before the unit is used again.

4.2 Important tips for gas heating or wood fuelled units and fireplaces.

Prevent discolouration of walls and ceilings!

There are always particles in the air in each living area even if the area is vacuum cleaned regularly!

These particles are easily visible when the sun streams in. This issue will not arise if the amount

of particles in the air is limited. If these particles are present in greater quantities and particularly

if the air is contaminated by soot and tar particles, for example, through the burning of candles or

oil lamps and cigarette or cigar smoke, then we can speak of a poor inner climate! Cooled air slowly

lows over the floor to the heater in a heated living area. This air is heated in the convection system

of the fireplace or heater, resulting in a quickly rising column of air that subsequently spreads through

the room again. This means there is always dust and other polluting particles depositing on cold and

often damp surfaces. This issue occurs especially in a new building (building damp) that is not yet dry.

An undesirable consequence of this phenomenon could be discolouration of walls and or ceiling!

How can this problem be avoided?

* With a newly built fireplace or following renovation, wait at least 6 weeks before firing up.

* The building damp must have disappeared completely from the walls, floor and ceiling.

* The room where the unit is located must be well ventilated.

* The required air ventilation must be in line with local building regulations.

* Limit the use of candles and oil lamps and keep the taper as short as possible.

* These two creators of atmosphere ensure considerable quantities of polluting and unhealthy

soot particles in your flat.

* Among other things, cigarettes and cigars contain tar that will precipitate on cold and damp

walls during heating.

* This may occur above radiators and light fittings and with ventilation grilles (if there is a poor

internal climate), although to a lesser degree.

4. THE FIRST FIRING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thermocet Trimline Quadro 46 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Thermocet Trimline Quadro 46

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info