Bedienungsanleitung Thermocet VERSA LV-HV (Seite 13 von 14) (Englisch)

607247

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

Page.13

This section to be kept by the customer This section to be returned by the customer (see re-

Important tips for heating with gas-fired or wood-fired stoves and fireplaces.

Prevent discolouration of walls and ceilings!

There are always dust particles in the air in every living space, even if it is regularly vacuumed! These particles are clearly visi-

ble in rays of sunlight and they will not bother you as long as the concentration of particles in the air remains low. The indoor cli-

mate can only be described as bad if these particles are floating through the room in larger quantities for any reason whatsoever

and, above all, if the air is additionally polluted by soot and tar particles caused by the burning of candles or oil lamps for example,

and by smoking cigarettes or cigars! In a heated living space, cooled air slowly streams across the floor to the combustion appli-

ance. This air is heated in the convection system of the stove or fire, causing a fast-rising column of warm air to develop, which

then spreads throughout the room again. As a consequence, this air always contains dust and other pollutant particles that will

leave deposits on cold and often damp surfaces. This is potentially a particular problem in new buildings that are not yet dry

(construction moisture). An unwelcome result of this phenomenon could be discolouration of walls and/or ceilings!

How can you prevent these problems?

If the gas-fired or wood-fired appliance is fitted with insulated covering, one of the following materials should only be used:

§ Loose white insulation wool (heat resistant to 1000°C)

§ Rocktherm 180.012 insulation wool (700°C) from Rockwool, or the equivalent

§ Other mineral insulation wool without binding agents (synthetic resins) or water-repellent substances (mineral oils).

Wait at least 6 weeks before firing a newly-bricked chimney or after renovations, since the construction moisture must have disap-

peared completely from walls, floor and ceiling. The room where the appliance is located must be well-ventilated and the required

ventilation must be in compliance with the stipulations of the local Buildings Decree. Use candles and oil lamps as little as possi-

ble and keep the wicks as short as possible. These two “atmospherics” provide considerable quantities of pollutant and unhealthy

soot particles in your home. Smoke from cigarettes and cigars contains tarry substances which will also leave deposits on colder

and damp walls when heated. If the interior climate is bad, this phenomenon may also occur above radiators and lighting fixtures

and at ventilation grilles, although to a lesser degree.

GUARANTEE CERTIFICATE

REGISTRATION CARD

Type of fireplace/heating appliance

Model

Serial number

Design

Name of customer

Street

Postcode, town/city

Telephone

Date of purchase

Name of supplier/installer

Street

Postcode, town/city

Signature and stamp Supplier/Installer

Type of fireplace/heating appliance

Model

Serial number

Design

Name of customer

Street

Postcode, town/city

Telephone

Date of purchase

Name of supplier/installer

Street

Postcode, town/city

Signature and stamp Supplier/Installer

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thermocet VERSA LV-HV Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info