Bedienungsanleitung Thermona THERM EL 45 (Seite 17 von 37) (Englisch)

600941

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

♦ DHW temperature display

If any other variable is displayed at the moment (heating water temperature, output, error message etc.),

pressing any of the buttons 2 opens the DHW temperature dialogue. This display is indicated by the °C pilot

light above button 4.

In the case of sensor defect or absence, the numerical data become replaced with dashes: _ _ _ during disconnection or interruption of the

sensor or wiring, ¯ ¯ ¯ after a short circuit on the sensor or wiring.

♦ Displaying and change (setting) of the desired DHW temperature value

If you press any of the ▲ , ▼ buttons (2) with the display showing the DHW temperature dialogue, you can

set its desired value. The setting process is indicated by flashing of the °C pilot control above the

O/I

(ENTER)

button (4). You can set the desired temperature value by pressing the ▲ , ▼ button (2) within the

range defined by the TU_ a TU¯ (P3.5 a P3.6) items of the service menu. The set value does not need to be

confirmed. The setting mode for the required values terminates 15 seconds after any of the ▲ , ▼ (2) buttons

has been last pressed.

The desired DHW temperature value can be set only if the rtU DHW heating mode is set to b_c (P3.2 = 2) (storage tank with the

temperature sensor).

♦ Switching the heating on or off

The heating mode can be switched on or off by pressing the

O/I (MENU)

button (3). The on-mode is

signalled by the pilot light between ▲ , ▼ buttons (1); the pilot light in the off-mode is turned off.

Heating can be switched on only if its operation is pre-set in the user menu; the rto item must be set to tEr, EtE, Prt, otP or ot- (P3.1 =

1 – 5).

♦ Switching the DHW heating on or off

The DHW heating mode can be switched on or off by pressing the

O/I (ENTER)

button (4). The on-mode

is signalled by the pilot light between ▲ , ▼ buttons (2); the pilot light is off if the DHW is in the off-mode.

The DHW heating can be switched on only if its operation has been pre-set in the service menu; the rtU item must be set to b_n or b_c

(P3.3 = 1 or 2).

♦ Displaying the outdoor/room temperatures

To display any other operational variables (except for the heating water and DHW temperatures), use the

(SELECT)

button (5). If you press (or double press) it, the outdoor/room temperature display dialogue opens.

This dialogue is indicated by the IN/OUT °C pilot light.

In the case of sensor defect or absence, the numerical data become replaced with dashes: _ _ _ during disconnection or interruption of the

sensor or wiring, ¯ ¯ ¯ during short circuit of the sensor or wiring

The difference between displaying the room or outdoor temperature rests only in the location of the sensor. Shall the boiler operation be

controlled on the basis of its data, the respective mode must be selected in the user menu:

- for rto = EtE (P3.1 = 2) (integrated equitherm regulation) outdoor sensor must be used,

- for rto = Prt (P3.1 = 3) (integrated room thermostat) sensor in the room of reference must be used.

If the sensor is connected but the boiler operation is not controlled on the basis of its data, these data are used at least for protecting the

system against freezing.

♦ Displaying the heating system pressure

If you press (or double press) the

(SELECT)

button (5), the system pressure dialogue opens. This display

dialogue is indicated by the bar pilot light.

Minimum operation pressure of the system is 0.5 bar.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thermona THERM EL 45 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info