Bedienungsanleitung Thermor Evidence (Seite 6 von 24) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Polnisch)

648121

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

7) Using the pilote wire

The product with pilote wire can receive the following signals from a master

unit :

- comfort (temperature of  control knob), (model Vivalto, Evidence Elec)

- eco (comfort temperature -3°C to -4°C), (model Vivalto, Evidence Elec)

- frost free (approximately 7°C)

- off.

Put the switch (1) to the programming mode (clock symbol).

The product must be connected through the pilote wire to a programming

control or a product equiped with pass program system in order to use

these different modes. You can control several convectors with a single

programmer or a product equiped with pass program system.

Warning :The control unit will consider frost free and off signals in any

switch selection.

RECOMMENDATIONS FOR USE

- There is no point in setting maximum heating, the room temperature will

not rise any quicker.

- When you air the room, disconnect the panel heater by putting the 

switch to

/0.

- If you leave for several hours, remember to reduce the temperature.

Absence for :

less than 2 hours, do not touch the controls.

2 to 24 hours, lower the  control knob by two graduations, set the

cursor  switch knob to .

more than 24 hours or in the summer, put the  control knob to

(mecanical), put the  switch on (electronic).

- If you have several units in a room, let them operate simultaneously. This

will give you a more uniform temperature without increasing electricity

consumption.

WARNINGS

Children must not lean on the appliance. Under certain circumstances,

there is a risk that its surface may cause burns to the skin of young

children. If there is any risk of this at all, install a protection grill.

This device is not intended for use by persons (including children)

with physical, sensory or mental disability, or by persons lacking

experience or knowledge, unless they have received from a person in

charge of their safety adequate supervision or preliminary instructions

on how to use the device.

Care must be taken at all times to keep children from playing with

the device.

Do not introduce objects or paper into the device.

Do not totally or partially block the grilles on the front or inside of the

appliance, as this may cause overheating. If the supply cord is damaged,

it must be replaced by a service agent or similarly qualiﬁ ed person in

order to avoid a hazard (applies to all units). All work to the inside of the

appliance must be carried out by a licensed electrician.

MAINTENANCE

To maintain performances of your unit, you should clean the upper and lower

grilles of the unit about twice a year using a vacuum cleaner or a brush.

Have a professional check the inside of the unit every ﬁ ve years.

Dirt may collect on the grille of the unit if the atmosphere is polluted. This

phenomenon is due to the poor quality of the ambient air. In this case, it

is recommended to check that the room is well ventilated (ventilation, air

inlet, etc.), and that the air is clean. The unit will not be replaced under the

guarantee because of this type of dirt.

The unit casing should be cleaned with a damp cloth, never use abrasive

products.

TROUBLE-SHOOTING

If the unit does not heat :

Check that the programmer is in COMFORT mode (electronical).

Make sure that the installation circuit breakers are switched on, or that the

load shedder (if you have one) has not switched off the unit power supply.

Check the air temperature in the room.

The unit does not carry out programming orders : (version with pilot

wire)

Make sure that the programming unit is being correctly used (refer to its

user’s manual) or that the Chronocarte is properly inserted in its housing and

that it is operating normally (batteries ?).

The unit is permanently heating :

Make sure that it is not in a draft and that the temperature setting has not been

changed.

This unit with electronic control is equipped with a microprocessor that can

be distribued by some severe mains voltage disturbances (outside EC

standards deﬁ ning the disturbance protection level). If there are any

problems (thermostat blocked, etc.) switch off the unit power supply (fuse,

circuit breaker, etc.) for about 5 minutes to allow the unit to start again.

Have your energy distributor check your power supply if the

phenomenon occurs frequently.

WARRANTY CONDITIONS :

KEEP THIS DOCUMENT IN A SAFE PLACE

(This certiﬁ cate should only be produced if you are making a complaint, attached with the invoice of the purchase)

- This guarantee is applicable for 2 years from the date of original purchase and shall be valid for no more than 30 months from the date of manufacture.

- Your Atlantic distributor will exchange parts shown to be defective in manufacture. The replacement parts will be of charge but Atlantic does not accept

responsability for freight or labor charges or losses in transit.

- This guarantee excludes damage by neglect, shipping or accident and any damage due to incorrect installation, use or purposes other than those intended

or failure to observe the instructions given.

* This information is shown on the plate which can be seen on the left-side or behind the front grille of the unit.



Atlantic UK Limited - The Old Mill - Mill Lane - Uckﬁ eld - East Sussex - TN22 5AA

Tel: 01825 767474, Fax : 01825 767478

E-mail: sales@atlantic-uk.co.uk

UNIT TYPE * :

SERIAL NUMBER * :

CUSTOMER’S NAME AND ADRESS :

Thermor Evidence Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info