Bedienungsanleitung Thermor TH5271225 - 150 VASB (Seite 27 von 32) (Deutsch, Englisch, Holländisch, Französisch, Polnisch)

648185

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

8) Programming mode :

This device has a thermostat capable of receiving orders through its pilot wire. It recognizes the following commands:

- CONFORT (comfort) : Temperature set using the thumb-wheel w

- CONFORT –1 (comfort –1) : Temperature set using the thumb-wheel w -1°C

- CONFORT -2 (comfort –2) : Temperature set using the thumb-wheel w -2°C

- ECO : Temperature set using the thumb-wheel v

- HORS GEL (frost-free) : Room temperature maintained at approximately 7°C

- ARRET (Off) : Immediate stoppage of the device (used for load-shedding).

To activate the programming mode set cursor u to

In this way, by connecting the pilot wire to a timer, you can program your Comfort and Economy temperature periods.

It is possible to connect several devices to one timer and, in this way, make energy savings.

NB: When there is no command given over the pilot wire, the device heats in the Comfort mode. HG and load-shedding

commands override the Economy and Comfort modes. On changing from the Comfort mode to the Economy mode,

the changeover time is approximately 12 seconds.

- There is no point in setting the unit to its maximum, the room temperature will not rise any faster.

- Switch the unit off by putting cursor u to

- Remember to lower the temperature f you go out for several hours.

If go out for : less than 2 hours, do not touch the controls.

from 2 hours to 24 hours, set the cursor u to

for more than 2 hours or during the summer, put the unit in Frost Free mode ( ).

If you have several units in the room, let them all operate at the same time, this will give a more uniform temperature

without increasing electricity consumption.

RECOMMANDATIONS FOR USE

WARNINGS

This appliance is not intended for use by young children or infirm persons without

supervision. Young children should be supervised to ansure that they do not play

with the appliance, lean against the front or insert objects or paper in it.

Do not totally or partially block the grilles on the front or inside of the appliance, as

this may cause overheating.

If the supply cord is damaged, it must be replaced by a service agent or similarly

qualified person in order to avoid a hazard (applies to units fitted with a supply cord

and plug).

Units fitted with a three core supply cord (brown, blue & black), must be directly

connected to fixed wiring by a licensed electrician.

All work on the interior of the appliance must be carried out by a licensed electrician.

To maintain performances of your unit, you should clean the upper and lower grilles of the unit about twice a year using

a vacuum cleaner or a brush.

Have a professional check the inside of the unit every five years.

Dirt may collect on the grille of the unit if the atmosphere is polluted. This phenomenon is due to the poor quality of

the ambient air. In this case, it is recommended to check that the room is well ventilated (ventilation, air inlet, etc.),

and that the air is clean. The unit will not be replaced under the guarantee because of this type of dirt.

The unit casing should be cleaned with a damp cloth, never use abrasive products.

MAINTENANCE

080214_CEETvariation_ang.PMD 07/09/05, 14:063

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thermor TH5271225 - 150 VASB Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info