Bedienungsanleitung Thetford S-OH70000 (Seite 12 von 15) (Englisch)

576908

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

The performance of this appliance meets the requirements of the European Standard

for Domestic Cooking Appliances (EN30) which specifies a maximum allowable

temperature rise of the furniture into which the appliance is installed of 65

C above the

ambient temperature. The installer should verify all furniture materials are suitable – ie

plastic materials may have a softening point lower than specified above.

We recommend the installation follows the minimum dimensions shown in this manual

as any deviation could result in excessive temperature rise. If minimum dimensions

must be reduced, due to design constraints, a temperature rise test of all furniture fitted

around the unit MUST be performed. The design is deemed permissible providing the

results of this test comply with all standards in force and the requirements detailed

within the furniture manufacturer’s material specification. Where minimum dimensions

are reduced we recommend protecting with non combustible material.

Gas Connection

Prior to connection ensure the local conditions for gas type and gas pressure match the

appliance specification. (Gas type and pressure for this appliance are printed on the

databadge located on the base of appliance)

The Ø8mm gas inlet is located to the rear of the appliance. Prior to connection remove the

plastic protection plug from the fitting. The appliance MUST be connected using metal pipe

manufactured from either copper, seam welded steel, seamless steel or stainless steel,

which complies to the requirements of EN1949. Rubber tubing MUST NOT be used.

Electrical Connection

Spark Ignition (12V DC)

The spark ignition generator MUST only be connected to a suitable 12V DC supply. We

recommend connecting to the generator using sheathed spade connectors.

Dual Fuel models

(230-240V ~ 50Hz)

Models fitted with power cord only

This appliance is supplied with a double insulated cord, type 227 IEC 53, HO5V V-F, which

is suitable for use up to 4 amps. This should be connected to a double pole switched

mains supply, with 3mm minimum contact separation at all poles in accordance with the

wiring rules. Ensure that all electrical cables and wires are routed well clear of any heat

source, including this appliance. Do not allow the cord to hang loose into the lower

compartment. The switch must be accessible after installation.

Models fitted with plug and power cord (UK only)

This appliance is supplied with a plug attached to the end of the power cord, for

connection to a switched wall mounted socket. After connection ensure the power cord

and any other electrical wires are routed well clear of any heat source, including this

appliance. Do not allow the cord to hang loose into the lower compartment. The switched

socket must be accessible after installation.

INSTALLATION

If the power cord is damaged, it must be replaced by the manufacturer, its

service agent or similarly qualified persons in order to avoid a hazard.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thetford S-OH70000 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Thetford S-OH70000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info