Bedienungsanleitung Thetford S-OH76000 (Seite 7 von 15) (Englisch)

576909

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

Gas Burners

(1) Ensure gas supply is connected and turned on. (2) Push in the control knob and turn

anticlockwise to full rate – large flame ( ). (3) Continue depressing the knob whilst

holding a lighted match to the burner. (4) After the burner is lit continue depressing the

knob for approximately 10 - 15 seconds. (5) Release knob and turn to required heat

setting. (6) If burner has not lit within 15 seconds, release knob and wait at least 1 minute

before repeating operations (2) to (5). (7) To turn off, rotate the control knob until the line

on the knob is aligned with dot on the control panel.

For models fitted with Spark Ignition the procedure is similar except that the burner is

ignited by depressing the ignition button located on the fascia.

Always make sure the control knob is in the off position when you have finished using the

hotplate burners.

Electric Hotplate (Dual Fuel Models Only)

(1) Ensure the electricity is switched on. (2) The hotplate control is numbered from 1 (Low)

to 6 (High). To turn it on, rotate the knob either clockwise or anti-clockwise to the required

heat setting. (3) To turn the hotplate off, rotate the knob until the line or pointer on the knob

lines up with the zero on the control panel.

The hotplate is a sealed construction and transfers heat through conduction. For maximum

efficiency use the correct size pan with a flat heavy gauge base. The pan size should be

the same or slightly larger than the hotplate (up to 1” / 2.5 cm oversize).

Before using your hotplate for the first time, we recommend that you prime and then

season it.

To prime the hotplate:-

Switch on the hotplate for a short period, without a pan, to harden and burn off the coating.

Use a medium to high setting for 3 – 5 minutes. A non toxic smoke may occur during this

process. Allow it to cool, then season.

To season the hotplate:-

Heat the hotplate for 30 seconds on a medium setting, then switch off. Pour a minimal

amount of unsalted vegetable oil onto a clean dry cloth or paper towel, and apply a thin

coat of oil to the hotplate surface. Wipe off any excess oil, then heat the hotplate on a

medium setting for 1 minute. Occasional seasoning will help to maintain the appearance.

OPERATION

•

Avoid old or misshapen pans as these may cause instability.

• The two in line Hob burners on this appliance will support pans from 10 to

20cm. The single hob burner will support pans from 10 to 22cm.

• Using larger pans may reduce performance or cause damage

•

The lid must be opened fully prior to using the hotplate burners

•

Children should be supervised to ensure they do not play with the

appliance

• Glass lids may shatter when heated. Turn off all burners and hotplate and

allow to cool before closing the glass lid.

•

Remove all spillage from the surface of the glass lid before opening.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thetford S-OH76000 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Thetford S-OH76000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info