Bedienungsanleitung Thetford S-OV72000 (Seite 18 von 19) (Englisch)

576918

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

MAINTENANCE & SERVICING

This appliance needs little maintenance other than cleaning. All parts should be

cleaned using warm soapy water. Do not use abrasive cleaners, steel wool or

cleansing powders. When cleaning the burner ring it is essential to ensure that the

holes do not become blocked. The control knobs are a push fit and can be removed for

cleaning.

1. Disconnect from gas supply

Open the oven door and remove the 3 screws from each side trim. Carefully slide

the appliance out one third and disconnect the gas supply from the front left hand

side of the appliance.

2. Remove appliance from housing

Check for any possible snagging of wires or pipes. If OK, lift appliance out onto a

suitable surface.

3. Control replacement

Disconnect from gas supply (1). Remove appliance from housing (2).

Open the oven door and unscrew the 2 screws holding the thermostat probe in

position and push the probe back out through the hole in the rear of oven. Remove

the 4 retaining screws from the bottom of the appliance and to the rear of the

control. This will remove the front curved fascia panel, this will allow access to the

two retaining screws on the front trim. Disconnect the inlet pipe and two burner

supply pipes. Remove the fittings off the old control and fit on the replacement.

4. Remove the grill burner

Disconnect from gas supply (1). Remove appliance from housing (2).

Open the oven door, and remove the top/sides insulation sheet. Drill the 4 pop

rivets on top of the roof, then Lever off the 2 starlock washers retaining the grill

burner.

5. Spark Ignition (where fitted)

Disconnect from gas supply (1). Remove appliance from housing (2).

Grill burner - Remove the screw from the bracket and spark ignition probe in the

top of the burner. Trace the electrode wire back to the generator and pull off the

connector.

Oven burner - Trace the electrode wire up the back of the cooker to the generator

and pull off the connector. Unscrew the fixing screw on the spark electrode inside

the oven cavity, then carefully pull the electrode from inside the oven and remove.

6. Grill burner injector (No62)

Disconnect from gas supply (1). Remove appliance from housing (2).

Release injector holder from bracket, disengage the grill pipe from the control and

remove the injector.

IMPORTANT

• Shut off gas supply at isolating valve, switch off electric supply and ensure all

parts are cool before cleaning or servicing

• All servicing must be carried out by an approved competent person.

• After each service the appliance must be checked for gas soundness

• This appliance must not be modified or adjusted unless authorized and carried

out by the manufacturer or his representative. No parts other than those supplied

by the manufacturer should be used on this appliance.

• If the supply cord is damaged, it must only be replaced by the manufacturer or his

representative in order to avoid a hazard.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thetford S-OV72000 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info