Bedienungsanleitung Thetford Top Line 169 (Seite 11 von 13) (Englisch)

576919

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

1. Ensure gas supply is connected and turned on.

2. Push in the control knob and turn anticlockwise to full rate – large flame ( ) Fig. 1.

3. Continue holding the knob depressed whilst the automatic ignition lights the burner. For

manual models hold a lighted match or taper to the burner.

4. After the burner is lit continue depressing the knob for approximately 10 - 15 seconds.

5. Release knob and turn to required heat setting – see Fig. 1.

6. If burner has not lit within 15 seconds, release knob and wait at least 1 minute before

repeating operations (2) to (5).

7. To turn off, rotate the control knob until the line on the knob is aligned with dot on the

control panel.

Always make sure the control knob is in the off position when you have finished using the

hotplate burners.

DO'S AND DON'TS

DO Read the user instructions carefully before using the appliance for

the first time.

DO Allow the burners to heat before using for the first time, in order

to expel any smells before the introduction of food.

DO Clean the appliance regularly.

DO Remove spills as soon as they occur.

DO Check that controls are in the off position when finished.

DO NOT Allow children near the appliance when in use. Turn pan handles

away from the front so that they cannot be caught accidentally.

DO NOT Allow fats or oils to build up in the base of the hotplate.

DO NOT Use abrasive cleaners or powders that will scratch the surfaces of

the hotplate.

DO NOT Under any circumstances use the appliance as a space heater.

LEAKS

If a smell of gas apparent, the supply should be turned off at the cylinder IMMEDIATELY.

Extinguish naked lights including cigarettes and pipes. Do not operate electrical switches. Open

all doors and windows to disperse any gas escape. Butane/Propane gas is heavier than air;

any gas escaping will therefore collect at low level. The strong unpleasant smell of gas will

enable the general area of the leak to be detected. Check that the gas is not escaping from an

unlit appliance. Never check for leaks with a naked flame; leak investigation should be carried

out using a leak detector spray or soapy solution.

This appliance needs little maintenance other than cleaning. All parts should be cleaned using

warm soapy water. Do not use abrasive cleaners, steel wool or cleansing powders. When

cleaning the burner ring it is essential to ensure that the holes do not become blocked. The

control knobs are a push fit and can be removed for cleaning. They are interchangeable without

affecting the sense of operation.

ALL SERVICING MUST BE CARRIED OUT BY AN APPROVED COMPETENT PERSON.

AFTER EACH SERVICE THE APPLIANCE MUST BE CHECKED FOR GAS SOUNDNESS.

OPERATION

MAINTENANCE & SERVICING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thetford Top Line 169 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Thetford Top Line 169

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info