699745

Thomson ROC1128SAM Seite 3

3
Zoom out
Zoom in
Vorherige Seite
1/38
Nächste Seite
4 5
GB
GB
2. Then press and release the target key on
the remote control you want learned.
3. If the LED ashes 3times and then remain
on, the command has been learned
successfully.
4. Repeat these steps to learn other key
functions.
5. Press the [MUTE] and [VOL-] buttons to
save all learnt functions and to exit the
learning mode.

While replacing the batteries, the remote control
will keep the functions of the learned keys.
    
     
1. Press and hold [MUTE] and [VOL+] keys
for 5seconds until the LED will be lit.
5
2. Enter the code [9] [8] [1], the LED will
ash 2times and then remain on.
3. Press and release the desired key at the
replacement remote control which you
want to clear the learned command. If the
LED ashes 3times, the learned command
has been cleared successfully.
     
1. Press and hold [MUTE] and [VOL+] keys for
5seconds until the LED will be lit.
5
1. Enter the code [9] [8] [2], the LED will ash
2times and then remain on.
2. Press and release the [OK] key at the
replacement remote control. If the LED
ashes 3times, all commands have been
cleared successfully.
  
This remote control is equipped with an 
.Thus you could reduce the functionality of
the remote control to its basic functions. It avoids
that the TV Settings arechanged by mistake.
During the   you still could use
following keys:
POWER TV ON /OFF
 Change your TV‘s volume
TV Mute
 Channel up/down
 Numeric keys 0–9toenter channel
numbers

Teletext ON /OFF /MIX
Use to select avariety of on screen
options
 Show the Electronic Program Guide
(if supported by the TV)
Input signal source /Indicator LED
Turn off the menu of the selected
product
 Switch to signal source TV
   
1. Press and hold [MUTE] and [VOL+] keys for
5seconds until the LED will be lit.
5
2. Enter the code [9] [7] [0], the LED will ash
two times and then remain on.
3. Press and release the [OK] key,ifLED ash
3times, you have entered the 
 successfully
   
1. Press and hold [MUTE] and [VOL+]
for 5seconds until the LED will be lit.
5
2. Enter the code [9] [7] [0], the LED will ash
two times and then remain on.
3. Press and release the [EXIT] key,ifLED
ash 3times, you have exit the 
.

While the   is activated only
the keys mentioned in chapter 7. will work.
If one of these keys is pressed the LED will
be lit until the key is released. If one key is
pressed during the normal mode, the LED
will ash.
 
•Donot mix new and used batteries for
powering the Universal Remote Control, as
old batteries tend to leak and may cause
power drain.
•Donot use corrosive or abrasive cleansers on
your Universal Remote Control.
•Keep the Universal Remote Control dust free
by wiping it with asoft, dry cloth.
 
Q. My Universal Remote Control does not
work at all!
A. Check your TV. If the TV main switch is
turned off, your Remote cannot operate
your TV.
A. Check whether your batteries are inserted
properly and are in the correct +/- position.
A. If the batteries are low, replace the
batteries.
Q. My TV responds only to some of the
commands.
A. Try other codes until most keys work
properly.
Q. Some keys of the Remote Control do not
work anymore?
A. Maybe the   had been
activated. Deactivate the   as
explained in chapter 7.2.
  
The manufacturer assumes no liability and
provides no warranty for damage resulting
from improper installation/mounting, improper
use of the product or from failure to observe
the operating instructions and/or safety notes.
   
Please contact Hama Product Consulting if you
have any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
  
  

After the implementation of the
European Directive 2012/19/EU and
2006/66/EU in the national legal
system, the following applies: Electric and
electronic devices as well as batteries must not
be disposed of with household waste.
Consumers are obliged by law to return
electrical and electronic devices as well as
batteries at the end of their service lives to the
public collecting points set up for this purpose
or point of sale. Details to this are defined by
the national law of the respective country. This
symbol on the product, the instruction manual
or the package indicates that aproduct is
subject to these regulations. By recycling,
reusing the materials or other forms of utilising
old devices/Batteries, you are making an
important contribution to protecting our
environment.
3 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

thomson-roc1128sam

Suche zurücksetzen

  • Wo finde ich die okay Taste auf der Fernbedienung? Eingereicht am 6-5-2020 13:42

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Thomson ROC1128SAM wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info