548794
41
Zoom out
Zoom in
Vorherige Seite
1/110
Nächste Seite
Chapter 4
SpeedTouch™ Internet Connectivity
E-DOC-CTC-20041126-0014 v3.0
39
4 SpeedTouch™ Internet Connectivity
Introduction This chapter provides information on how to configure your SpeedTouch™
according to your preferences and how to access the Internet.
Access methods As soon as the SpeedTouch™ and your computers have been configured as
outlined in “3 Configuration” on page 37, you are able to connect to the WAN or
Internet.
Depending on the configuration of the SpeedTouch™ you may have:
Direct access
As soon as the initial configuration has been done, continuous and immediate
access is available via the DSL line.
Dial-in access
Access must be explicitly established, e.g. by “dialing” into a Broadband
Remote Access Server (BRAS).
The applied connection protocol model depends on the service profile you selected
to configure the SpeedTouch™ and should correspond with the Service Provider’s
requirements.
Direct access As mentioned, as soon as the initial configuration has been done, immediate and
uninterrupted WAN access is provided.
Dial-in access The SpeedTouch™ supports both most popular connection methods: PPP over ATM
(PPPoA) and PPP over Ethernet (PPPoE).
The connection method depends on the service profile you selected to configure
the SpeedTouch™ and should correspond with the service Provider’s requirements.
Routed PPPoA: the SpeedTouch™ needs to be configured for the Routed
PPPoA Service.
Routed PPPoE: the SpeedTouch™ needs to be configured for the Routed
PPPoE Service.
Both Services are available via the SpeedTouch™ Quick Setup.
Using the
SpeedTouch™
PPP dial-in client
SpeedTouch™’s embedded PPP dial-in client allows you to establish an Internet
connection for all (or a selection of) computers residing on your local network,
using only one computer of the network to control the client.
If this computer runs:
MS Windows XP
you can use MS Windows XP’s Internet Gateway Device Control Client.
See “4.1 Using the MS Windows XP Internet Gateway Device Control Agent”
on page 40 to proceed.
Another Operating System
you can use the SpeedTouch™ web pages.
See “4.2 Using the SpeedTouch™ Web Pages” on page 42 to proceed.
In case of direct access, the remote organization might ask for a user name
and password on an Internet welcome page.
41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Thomson SpeedTouch 716g wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info