Bedienungsanleitung Thule 307369 Lift V16 - 12V motor (Seite 14 von 36) (Alle Sprachen)

800431

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

14 OBL906-05

• Even when there is no power the bike rack may be closed by hand, close all straps. Secure

also the bike rack with the strap of 2.5m to the baseframe.

• If the bike rack stops at the start of the opening of the THULE LIFT, gently push the bike

rack until movement recommences.

• Always drive with a closed THULE LIFT and always x the outer bike to the frame by

means of an included strap .

• You can install a switch inside the vehicle that cuts off the power, preventing undesired

opening of the LIFT.

The electronic device may only be installed by qualied personnel from a specialist company

(in Germany in accordance with VDE 0100, Part 721). The following information is intended for

specialists who are familiar with the guidelines and safety precautions to be applied.

Caution!

Safety instruction relating to danger emanating from electrical currents or voltage: failure to

observe this instruction can cause material damage or personal injury and impair the proper

functioning of the device.

The manufacturer will not be held liable for claims for damage resulting from the following:

• Faulty assembly or connection

• Damage to the appliance resulting from mechanical inuences and excess voltage

• Alterations to the device without express permission from the manufacturer

• Use for purposes other than those described in the operating manual

Warning!

To prevent short circuits, always disconnect the negative terminal of the electrical system before

working on the vehicle. If the vehicle has an additional battery, its negative terminal should also

be disconnected.

Warning!

Inadequate supply cable connections could result in short circuits with the consequence that:

• Cable res occur

• The airbag is triggered

• Electronic control devices are damaged

• Electric functions fail (indicators, brake light, horn, ignition, lights)

INSTALLING & CONNECTING THE POWER CABLE

Thule NV recommends that you connect the power cable to the fuse box or terminal block and

not directly to the battery;

Choose the safest and shortest installation route for the power cable.

Shorten the power cable as required.

Caution

Only use cable clips that are suitable for the diameter of the power cable for the connection to

the fuse box, terminal block or battery. If the wrong terminals are used, it could cause a voltage

drop and increase heat formation at the terminal.

Use the correct fuse to the connection with the vehicle’s power supply according the wiring

diagram and according EN 1648-1 & EN 1648-2.

Caution

Installing the wrong fuse can cause cable re in case of a short circuit or malfunction!

If the length of the supplied power cable is not sufcient, the connection cable must be replaced

with a new connection cable with a larger cable diameter.

Thule NV is not responsible for any misprints.

This instruction may be changed without prior notice. We do not accept responsibility for any

possible errors in the content.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thule 307369 Lift V16 - 12V motor Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info