3332
For Finish Mode, you can set the following values:
➤ Pre-set or custom event distance (for custom, you can set the
distance up to 999.99)
➤ Unit (NM, KM, or MI)
➤ Target time
➤ Alert option (an audible alert will cause the Watch to both beep
and flash the predicted finish time and a silent alert will only
flash the predicted finish time)
Operating Finish Mode
1. Press MODE until Finish Mode appears.
2. Press START/SPLIT to begin timing.
3. Press START/SPLIT again to take a split and automatically begin
timing a new lap.
4. Press STOP/RESET to stop timing when you reach the end of your
activity.
5. Press START/SPLIT to continue timing or
6. Press and hold STOP/RESET again to reset the display to zero.
on pace for your predicted finish, you can set the Watch to alert
you if you are moving either too quickly or too slowly for your
desired pace.
If you do not use the GPS-3D Sensor, you will see the message NO
GPS DATA and you cannot enter Finish Mode. Additionally, you
must reset the chronograph to zero prior to operating Finish Mode
or it will not operate properly.
Finish Mode Terminology
Target time: Your desired time to complete the race or workout.
The Watch uses this time to alert you if you are going too slowly to
complete the event within the selected time.
Setting Finish Mode
You must stop and reset the chronograph to allow the configuration
of Finish Mode. However, you can still configure Finish Mode even
when you see the message NO GPS DATA displayed.
1. While in Finish Mode, press and hold the SET button until the word
SET briefly appears on the display, followed by a flashing value.
2. Set the first value by pressing + (DISPLAY) or – (STOP/RESET).
3. Press SELECT (SET/FORMAT) to move to the next value to set.
4. Repeat steps 2 and 3 for all the values that need adjustment.
5. Press DONE (MODE) to save your changes and complete the setting
process.
608-095000_W219_NA_EN_T-0411-16_TMX_W188_EN.qxd 3/10/11 2:54 PM Page 32
